93 blazer dies when warmed up
#1
93 blazer dies when warmed up
My 93 blazer runs fine until it gets warms up then it stalls or skips a bit then dies it will restart but then dies again any ideas to what would be causing this to happen any ideas are greatly appreciated...
#3
Maybe the same issue?
Does somebody have an idea on how to isolate this issue. I have no time at the moment to dig into the schematics and figure if we could measure the output signal of the crank position sensor.
Check this: https://blazerforum.com/forum/1st-ge...hen-hot-88349/
Does somebody have an idea on how to isolate this issue. I have no time at the moment to dig into the schematics and figure if we could measure the output signal of the crank position sensor.
Check this: https://blazerforum.com/forum/1st-ge...hen-hot-88349/
Thread
Thread Starter
Forum
Replies
Last Post
PseudoKirby
2nd Generation S-series (1995-2005) Tech
9
10-10-2011 09:41 AM
KK808
Engine & Transmission
3
03-02-2009 01:44 PM
Poligono
2nd Generation S-series (1995-2005) Tech
5
11-03-2008 06:01 PM