Driveshaft help
#1
Driveshaft help
Hey guys/gals. I thank you for the help.
Today well yesterday I ran into a problem.
I am working on my 92 Blazer. I marked the the driveshaft/transfer case and driveshaft/axle.. Well my front end was engaged and I left it in neutral and it rolled last night. I tried to put it back where it was but now I cant seem to line up to splines. It goes in half way and just stops... I noticed a (Missing) spline on the driveshaft yoke? but cant seem to find the notch on the output shaft in the transfercase.
I hope I can get some help. I got to be to work at midnight and its only going to be so warm outside for so long. Im in my driveway.
Next time the wife tells me to drop my truck so the trailer park doesn't complain... I am leaving it up!
Thank you, I hope it makes sense.
Today well yesterday I ran into a problem.
I am working on my 92 Blazer. I marked the the driveshaft/transfer case and driveshaft/axle.. Well my front end was engaged and I left it in neutral and it rolled last night. I tried to put it back where it was but now I cant seem to line up to splines. It goes in half way and just stops... I noticed a (Missing) spline on the driveshaft yoke? but cant seem to find the notch on the output shaft in the transfercase.
I hope I can get some help. I got to be to work at midnight and its only going to be so warm outside for so long. Im in my driveway.
Next time the wife tells me to drop my truck so the trailer park doesn't complain... I am leaving it up!
Thank you, I hope it makes sense.
#2
Please disregard this posting. I figured out what my problem was. My truck is up and doing donuts once again. Thank you for reading. If possible you can delete this.
Thank You All.
Thank You All.
Thread
Thread Starter
Forum
Replies
Last Post
gitch93
Steering, Suspension & Drivetrain
5
01-23-2013 04:51 PM
87k5blazerbrat
Full Size K5 (1969-1991) GMT415 (1992-1994) Tech
7
12-29-2011 09:16 PM
trudynosports
2nd Generation S-series (1995-2005) Tech
2
12-13-2005 09:40 PM