emergency brake handle
#1
emergency brake handle
got the bottom of the dash( under the wheel) mostly off. the emergency brake handle won't allow me to remove the final step.
i must say there isn't to much room to get in there and make a hole thru the firewall to hookup some toggle switches.
any input ???????????????????????????????
i must say there isn't to much room to get in there and make a hole thru the firewall to hookup some toggle switches.
any input ???????????????????????????????
#3
handle
i see the linkage on the inside of the plastic dash. but i don't know how to separate it from the handle' i don't want to pull hard on the handle and break it. i thought there might be a screw that holds it in place but there is not one.
#4
I just went and looked at mine. Removing the wire is very simple. Take one finger and pull the metal lever towards you. Use the other hand and push up(towards the roof of the truck) on the wire. It should pop right out.
If you can't figure out what I'm talking about, look under the dash while you pull the brake release. Se the mechanism that's moving? That's the lever you need to manually move.
If you can't figure out what I'm talking about, look under the dash while you pull the brake release. Se the mechanism that's moving? That's the lever you need to manually move.
#6
brake handle
thank you, i just can't get it off. i lifted pull twisted and that.
i am only slightly mechanically inclined.
i have the dash hanging down with the brake lever holding on.
i will bring it down to my body guy tomorrow and it will take him 2 seconds to get it off.
thanks again..................................
i am only slightly mechanically inclined.
i have the dash hanging down with the brake lever holding on.
i will bring it down to my body guy tomorrow and it will take him 2 seconds to get it off.
thanks again..................................
Thread
Thread Starter
Forum
Replies
Last Post
mow10man
2nd Generation S-series (1995-2005) Tech
6
04-19-2008 09:16 PM