02 Vortech
12-02-2005, 01:46 AM
If you guys are familiar w/ s10forum.com many people have resorted to bottle fed fun- There are guys running 125 shot on stock 4.3L motor (not stock fuel system)- and are fine- some are running advanced timing on a 100 shot !!!! - The best #'s so far are 299whp and 402 w ft. lbs and runs 12.5 in the 1/4 on stock block / transmission (shift kit / servos/ trans cooler/ .490 valve)- For me i shaved 1.5 seconds off on the 75 flywheel hp shot- THE 4.3L loves the bottle - it can handle alot of it due to low compression ratio (9:1)- and nitrous makes about double the torque as it does HP. The 4.3L already makes alot of torque- so this means you have a torque monster on your hands.
DONT BE SCARED OF NITROUS-
IF U USE YOUR HEAD, GET QUALITY PARTS, INSTALL IT CORRECTLY, AND USE SOME SAFEGUARDS YOU CAN HAVE YEARS OF BOTTLE FED FUN-
( Parts with " * " before them arent required but are nice to have)
HERES WHAT YOU NEED FOR A SAFE AND EFFECTIVE 55 /120HP -(some guys are running 200 shot on totally built block!!!)
A good base kit- I recommend Cold fusion or Nitrous express (cold fusion has lifetime warranty)
v6 single fogger EFI wet kit- (comes with bottle / solenoids / lines / microswitch / switchs/ wiring for complete install)
A purge (dyno tune makes a quality unit)
*A automated bottle heater (dynotune makes a fully automated one) Also if you bottle pressure isnt between 900psi and 1100psi your not getting your full shot of nitrous - so if you spray a 50 shot at 500psi you maybe are getting a 25 to 30hp shot (BOOO!)
*A Automated bottle opener- (Cold fusion makes a cost effective one)
Nitrous pressure guage- (dynotune makes good ones)( or you can just get a bottle pressure guage from ZEX ($50))
Cold spark plugs- AC DELCO R42LTS (nappa)
*High performance oil- Royal purple 10w30 (my oil pressure never fluctuates when its hot out anymore meaning i got better protection and lubrication)
*Fuel pressure guage- (dynotune once again)
A NOS fuel pressure safety switch- from my local speed shop
*A Dynotune A/F ratio nitrous shut off switch
A MSD DIGITAL RPM WINDOW SWITCH - THIS IS REQUIRED WHEN RUNNING automatic transmission (doesnt let you spray through shift)
WEBSITES FOR PRODUCTS LISTED ABOVE-
Dynotunenitrous.com
Zex.com
msdignition.com
http://www.coldfusionnitrous.com/
nitrousexpress.com
DONT BE SCARED OF NITROUS-
IF U USE YOUR HEAD, GET QUALITY PARTS, INSTALL IT CORRECTLY, AND USE SOME SAFEGUARDS YOU CAN HAVE YEARS OF BOTTLE FED FUN-
( Parts with " * " before them arent required but are nice to have)
HERES WHAT YOU NEED FOR A SAFE AND EFFECTIVE 55 /120HP -(some guys are running 200 shot on totally built block!!!)
A good base kit- I recommend Cold fusion or Nitrous express (cold fusion has lifetime warranty)
v6 single fogger EFI wet kit- (comes with bottle / solenoids / lines / microswitch / switchs/ wiring for complete install)
A purge (dyno tune makes a quality unit)
*A automated bottle heater (dynotune makes a fully automated one) Also if you bottle pressure isnt between 900psi and 1100psi your not getting your full shot of nitrous - so if you spray a 50 shot at 500psi you maybe are getting a 25 to 30hp shot (BOOO!)
*A Automated bottle opener- (Cold fusion makes a cost effective one)
Nitrous pressure guage- (dynotune makes good ones)( or you can just get a bottle pressure guage from ZEX ($50))
Cold spark plugs- AC DELCO R42LTS (nappa)
*High performance oil- Royal purple 10w30 (my oil pressure never fluctuates when its hot out anymore meaning i got better protection and lubrication)
*Fuel pressure guage- (dynotune once again)
A NOS fuel pressure safety switch- from my local speed shop
*A Dynotune A/F ratio nitrous shut off switch
A MSD DIGITAL RPM WINDOW SWITCH - THIS IS REQUIRED WHEN RUNNING automatic transmission (doesnt let you spray through shift)
WEBSITES FOR PRODUCTS LISTED ABOVE-
Dynotunenitrous.com
Zex.com
msdignition.com
http://www.coldfusionnitrous.com/
nitrousexpress.com