dmb1605
02-23-2005, 12:50 AM
whats up fellas, ive had my zr2 blazer since summer nad its good so far to me .... have any of you guys had problems with the fgas gauge? once i hit about 1/4 tank left it will bounce from empty to full to empty and on ... i havent really looked into it yet but if any of you guys have/had this problem, let me know
01xtreme
02-23-2005, 01:46 AM
I have the same the problem with mine once in a while. If you find anything out, let me know.
benzodogg
02-23-2005, 05:13 AM
Guys, I dont think anything is wrong with your gauge. In the 1997 Tahoes they installed a smart gas gauge, supposed to match your gas left in the tank with your average speed. It fluctuates all the time...I wouldnt worry, some of the Blazers have this installed too. If it gets on your nerves and the car is under warranty. Take it back and ask the dealer to put a new one in, its really not the gauge, just the sensor. Let me know if I am wrong.
01xtreme
02-23-2005, 10:15 PM
It still has me worried a bit, whenever I'm low on gas, and it's not quite payday and I'm trying to stretch it out, yeah, the nerves start to kick in. But I had like 1/4 tank left, the overhead console said 347 miles left, and the gauge bounced up and down like three times. This is while I was sitting in my blazer at work for lunch (the blazer had been sitting there for at least 3 1/2 hours.) No warranty though :( It doesn't do it all the time though. My blazer has an attitude problem.
benzodogg
02-24-2005, 02:35 PM
Yeah, if your Xtreme has an overhead console, im willing to bet that it has this "smart" gauge. At any rate, the reason it bounces so much is that it is measured by a float, when the gas has sloshed around some times, it likes to dance, and put on a show. I would call the dealer just ask them to look up your VIN number and they will tell you what options were put on your car....
BLAZINBlaZer98
03-01-2005, 02:10 PM
i have this problem also, dont get me wrong, i love my blazer more than anything, im gonna drive it till its undriveable, but my gas gage works if i fill up all the way, just for alittle bit, but does anyone know a fix for this? is it the wiring, or the ascending unit?