won't start after replacing intake manifold gaskets
#1
won't start after replacing intake manifold gaskets
2000 olds bravada replaced intake gaskets and now can't get to run. Have adjusted distributor various times thinking it was the timing I did the edi engine timing proceedure. I will do it again today, I have fuel and spark. I need help to fix this
#2
when you crank the engine what exactly is it doing?
no reponse?
terrible idle?
need some details.
no reponse?
terrible idle?
need some details.
#3
When I did a intake on my 98 I had to crank that thing like 100 times. The cylinders were so full of antifreeze and oil. After it finally fired up. Took a while to burn all that crap outta there then ran great.
Thread
Thread Starter
Forum
Replies
Last Post
koreiryuu
2nd Generation S-series (1995-2005) Tech
5
08-26-2014 10:09 PM
jack hammer
2nd Generation S-series (1995-2005) Tech
50
09-26-2013 09:56 PM
gsaum
2nd Generation S-series (1995-2005) Tech
12
04-09-2013 11:37 AM
greg94
1st Generation S-series (1983-1994) Tech
3
11-17-2010 09:15 AM
jspafford
2nd Generation S-series (1995-2005) Tech
3
05-27-2009 09:03 AM