what have you gotten done on your blazer today?
In the last week I have put in new gaskets and seals in the manifold and valve covers and upper manifold and put in a brand new fuel injection spider and a new oil pressure sending unit and new distributor and cap and rotor new spark plugs and wires new blacked out taillights new water pump and a new power brake booster and new abs wheel speed sensors for front left and right and added a new abs control module. And ive blacked out the chevy logos and Blazer logos. Ive also added 2 15 inch subwoofer and infinity mids and highs and a headunit with dvd player and 2 punch amps 1 running my subs and the other running my mids and highs, ive also blacked out the front chrome piece that goes across the front grill. And i stripped the paint from my luggage rack and redid it with bedliner spray and looks awesome. I've still got more I'll be doing next week.
Last edited by ThaDopeShow; 01-22-2017 at 06:12 PM.
Took my wheel spacers off... The stance would look alright if I were running larger tires, but with the tires on it now it just looked too wide... Took 1.25" inches away from width on either side, she actually looks a little taller now :P As an added bonus, my 55+mph vibration went away. Who knew?!?!
Did nothing to it today. But found out the front driver wheel bearing is bad.
Thankfully its 2wd and the hubs/bearing assembly is not expensive. Also outer tie rod on passenger side has a little play. I will worry about that when its warmer
Thankfully its 2wd and the hubs/bearing assembly is not expensive. Also outer tie rod on passenger side has a little play. I will worry about that when its warmer
I've done nothing to it in a couple of months. :-(
Still sitting after the tranny started to slip, so I parked it. About to pull it into the garage next week to drop the transmission for a rebuild. Not sure how bad it is, but the fluid is darker than a politicians soul. Already have a new billet dizzy for it, so I will do lower intake gaskets, new spider assembly, new dizzy & the trans all at the same time. Just in time for Spring.
Still sitting after the tranny started to slip, so I parked it. About to pull it into the garage next week to drop the transmission for a rebuild. Not sure how bad it is, but the fluid is darker than a politicians soul. Already have a new billet dizzy for it, so I will do lower intake gaskets, new spider assembly, new dizzy & the trans all at the same time. Just in time for Spring.
Hinge Pins
With the help of my Brother in law in his shop I replaced the hinge pins on the driver side front door. The 3 inches or so of sag is now gone and it closes much better and no whistling noise when I drive.