1987 S10 Blazer Oil Sending wiring
#1
1987 S10 Blazer Oil Sending wiring
i am having an issue with getting my truck to start again after i literally ripped my sending unit (i have the dual unit set up, light and gauge) wiring harness.
i know i need to replace my pigtail connector as the wires are pulled out almost all the way... But all wires are still somewhat hanging on.
My problem is there is a light brownish wire just hanging free all mangled but i have no clue where it came from nor do i see evidence of the opposite end. It is connected to the same loom/wire harness as the senders.
Pics shortly, thanks in advance,
JOSH
i know i need to replace my pigtail connector as the wires are pulled out almost all the way... But all wires are still somewhat hanging on.
My problem is there is a light brownish wire just hanging free all mangled but i have no clue where it came from nor do i see evidence of the opposite end. It is connected to the same loom/wire harness as the senders.
Pics shortly, thanks in advance,
JOSH
Thread
Thread Starter
Forum
Replies
Last Post
phatnogin5877
2nd Generation S-series (1995-2005) Tech
12
05-29-2012 07:12 PM
mdkuni
2nd Generation S-series (1995-2005) Tech
14
09-25-2008 10:54 AM