93 s10 blazaer stalling again after doing rebuild
#41
Replaced the rotor and distributor in my 93 w code and set the time. The dist had a lot of crud in it and a lot of button wear. Runs much better
#42
Replaced ECU.
Replaced ECU like 3 months ago. No sign of strange power issue. Knock on wood so far.
TTFN,
Josh
TTFN,
Josh
#43
STUMPED. runs good but.....
Facts: Runs good at idle and under cruise conditions like under 45 maybe 50. Sputters at high rpm. partial throttle responds with bogging. stab it to the floor and it will go better but not perfect. code 42 showed up on scanner. replace spark module, and ignition coil. ran OHMS test on Pick Up coil. Same problem exists. Fuel pressure is up at 60psi key on, 56 at idle, and 55 at approx 1800 rpm. Any ideas where I need to check?
#44
This thread is over a year old, Please start a new thread so we can help you. Thank you.
Thread
Thread Starter
Forum
Replies
Last Post
chevyracingfan23
2nd Generation S-series (1995-2005) Tech
14
06-19-2012 03:32 PM
dylan71
2nd Generation S-series (1995-2005) Tech
12
04-25-2011 09:39 AM
gatelocked
2nd Generation S-series (1995-2005) Tech
2
02-28-2011 05:52 PM
KRUSHER
2nd Generation S-series (1995-2005) Tech
3
01-02-2010 08:25 PM
c.andrew
2nd Generation S-series (1995-2005) Tech
5
10-28-2009 02:28 AM