2000 Blazer Front Seat Removal
#22
So my original seats were cloth.... But I think had a plug connected for lumbar.
Pictured is my car plug and new seat plug.
I was never aware of the seat plugs being different... But ya learn something everyday, I guess.
Pictured is my car plug and new seat plug.
I was never aware of the seat plugs being different... But ya learn something everyday, I guess.
#23
So got the driver one in no problem other then the different plug
BUT now when I went to do the passenger I can not find the power plug.
Dug around pretty good under the carpet but came up empty.
Figure if one side was wired both should be
Any one have any ideas?
BUT now when I went to do the passenger I can not find the power plug.
Dug around pretty good under the carpet but came up empty.
Figure if one side was wired both should be
Any one have any ideas?
#24
How far back did you reach in for the plug on the passenger side? I had my arm in up to my elbow through the hole in the carpet under the passenger side seat, reaching back towards the rear seat area. The plug and harness was taped up to another part of the body harness back there. I just grabbed and pulled and it popped free and pulled it up and out of the hole.
#25
thanks again for the quick response.
I removed the center console and was reaching towards the front of the vehicle and under where the console was.
Looks like I might have been reaching in the wrong direction...
I'll have to give it another shot tomorrow
I removed the center console and was reaching towards the front of the vehicle and under where the console was.
Looks like I might have been reaching in the wrong direction...
I'll have to give it another shot tomorrow
Thread
Thread Starter
Forum
Replies
Last Post
LilMsChevy
Engine & Transmission
0
01-11-2010 09:45 PM