Looking for a Diagram for Catalytic Converter Replacement
#11
One person job as nothing is heavy. Very likely that you will have to replace all the bolts as rust and all the heat/cool cycles have taken their toll so all the bolts will twist into two pieces.
Plan on three hours.
I did this in my concrete driveway with Blazer sitting on ground.
As far as a step by step procedure....nothing exists that I know of. Actually a rather easy job to do except for dealing with the rusted bolts.
Use new gasket(s); I think there is only one.
Be glad to help out but a bit of distance between us.
Good luck.
Plan on three hours.
I did this in my concrete driveway with Blazer sitting on ground.
As far as a step by step procedure....nothing exists that I know of. Actually a rather easy job to do except for dealing with the rusted bolts.
Use new gasket(s); I think there is only one.
Be glad to help out but a bit of distance between us.
Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
88s10Blazer
1st Generation S-series (1983-1994) Tech
1
09-21-2007 06:50 PM
sgtbrum
2nd Generation S-series (1995-2005) Tech
3
12-18-2006 11:29 AM