Plug Wires with Headers?
#1
Plug Wires with Headers?
I have a 2002 4.3 in a jeep. We just 3-linked the front suspension and added Sanderson CV95 "block hugger" style headers and I'm looking for a 90 degree boot, universal plug wire kit that I can route down (away from the primaries) and then up the back of the heads to distributor. There are a variety of kits out there, but wanted to ask if there are any recommended that will for sure include the correct ends for the stock distributor.
Thanks!
Thanks!
#2
I have a 2002 4.3 in a jeep. We just 3-linked the front suspension and added Sanderson CV95 "block hugger" style headers and I'm looking for a 90 degree boot, universal plug wire kit that I can route down (away from the primaries) and then up the back of the heads to distributor. There are a variety of kits out there, but wanted to ask if there are any recommended that will for sure include the correct ends for the stock distributor.
Thanks!
Thanks!
#3
Thanks, but looking for a 90 deg universal set with straight boots on the distributor end the fit the stock cap. My plan is to route the wires down and then sweep them up the backs of the heads. Thanks again.
#4
.
The link above on Amazon had the best photo. Below is the Jegs link.
https://www.jegs.com/i/Taylor/895/46052/10002/-1
Finally the Taylor web site listing them for both LT1 and Vortec
http://www.taylorvertex.com/spark-pl...and-terminals/
You should be able to put these on the distributor end of a universal set of the right diameter.
Last edited by LesMyer; 05-14-2019 at 12:19 PM.
Thread
Thread Starter
Forum
Replies
Last Post
theeviltwinn
2nd Generation S-series (1995-2005) Tech
4
10-19-2010 06:23 AM
Indianarocker
2nd Generation S-series (1995-2005) Tech
5
05-24-2009 04:24 PM
Fishin_Freak
2nd Generation S-series (1995-2005) Tech
15
04-22-2009 01:09 PM
phantom
2nd Generation S-series (1995-2005) Tech
7
02-20-2008 11:20 PM