Reading obd 1.5
#1
Reading obd 1.5
My CEL is flashing and truck is running worse. Some codes will pull with an obd II reader but not the one that's making it flash. Can I jump it like an obd1 and get the code?
#2
Flashing means you have a misfire.
#3
Hm I feel like I should of already known that. Well I replaced the fpr and then the tps. Its been running ok but not good. Last night it got a whole lot worse and it runs rich already. I'm thinking the spider or nut kit but I don't have the money till the 1st to start buying parts again.
#4
#5
Haha yes we do like to break stuff.. our "mechanics" hated us. We always broke our trucks!
#6
I bought an AutoXray scanner that reads OBDI and OBDII codes to use on mine. Also if it's OBD 1.5 you have to buy a special cable for it. Got it on ebay cheap
#7
Well obd 2 has ready every code my trucks thrown except the flashing SES. But I was kindly reminded that's a misfire
Thread
Thread Starter
Forum
Replies
Last Post
ivannj
2nd Generation S-series (1995-2005) Tech
11
01-13-2006 11:47 PM