Replacing Control Arms, Shocks, Tie Rods 96 Blazer
#1
08-06-2014, 07:00 PM
Replacing Control Arms, Shocks, Tie Rods 96 Blazer
This weekend I will be replacing both upper control arms (all arms come with rivited ball joints) and the lower right control arm.
I also will be replacing both front shocks and both tie rods.
Besides unloading the torsion bar for the lower arm (ill probably use a bolt and a jack), are there any other special tools I will need or any problems anybody here has run into while doing these replacements. Any tips? Anything else I should buy in advance before starting the project? All I have are the parts mentioned above plus a garage filled with MOST tools.
1996 Chevy Blazer 4wd
I also will be replacing both front shocks and both tie rods.
Besides unloading the torsion bar for the lower arm (ill probably use a bolt and a jack), are there any other special tools I will need or any problems anybody here has run into while doing these replacements. Any tips? Anything else I should buy in advance before starting the project? All I have are the parts mentioned above plus a garage filled with MOST tools.
1996 Chevy Blazer 4wd
Last edited by Cassera; 08-06-2014 at 07:08 PM.
Thread
Thread Starter
Forum
Replies
Last Post
GunsOfNavarone
Steering, Suspension & Drivetrain
3
12-15-2014 04:25 AM
Yooper
Steering, Suspension & Drivetrain
7
07-26-2009 03:01 PM
