distributor drive gear installation ?
i was in the process of replacing a bad lower intake gasket and discovered that the distributor drive gear is badly worn, got the old one off and am waiting on the new one to arrive. i didnt notice until after i got the gear off that there is a dimple on the gear, how does the dimple align with the rotor when its together? i figure if my marks dont line up when i put it back in, im 180 off, but if theres a way to know how to have it lined up right befoore its put in, that would be a good thing.
|
On my '98 the metal tab of the rotor is on basically the opposite side from the electrical connector with the dimple lined up on the paint mark on the distributor shaft. "1" & "3" on the following image at this link distributor_alignment.gif Photo by swartlkk | Photobucket
This link has a lot of detail and is where I pulled the image from https://blazerforum.com/forum/tech-a...-timing-24373/ |
All times are GMT -5. The time now is 04:18 AM. |
© 2024 MH Sub I, LLC dba Internet Brands