Rubber Ducky - 00 Blazer D44 SAS
#55
I apologize for the lack of updates. So got the whole truck slammed together and took it out for the second test drive and spun a rod bearing 2 miles from the garage. When I deleted the oil cooler lines didn’t notice the remote oring up there and double sealed the oil filter. Anywho last month spent rebuilding the engine and finally got it back in the truck last weekend.
Right now having a few misfire issues from plugs or also I think I have an intake vacuum leak which hopefully I can fix this weekend. But also have to get everything packed in the trailer because I’m moving to Colorado beginning of April! I’ll try to get some more updates and pictures this weekend though! It’s coming just slow lol
Right now having a few misfire issues from plugs or also I think I have an intake vacuum leak which hopefully I can fix this weekend. But also have to get everything packed in the trailer because I’m moving to Colorado beginning of April! I’ll try to get some more updates and pictures this weekend though! It’s coming just slow lol
#56
Sucks about the work. Awesome about Colorado! I've always wanted to go there... might take the blazer for a road trip next summer...
looking forward to the updates, no rush on them lol just wondered if you did anything with her after the build! Lol
looking forward to the updates, no rush on them lol just wondered if you did anything with her after the build! Lol
#57
Race stickers because custom built :P
Rock lights
Rear flex at Uwharrie
Ram Offroad Park, Colorado Springs, CO; felt like I was going to roll for sure but was perfectly fine.
Front flex
Rear flex on the mountain
Snowed last night
#58
Also, does anyone remember which wire needs connected to allow the transmission to shift while in 4 low? I've been attempting to search for it on here again because an issue I've noticed but can't remember where I read that way back when. I know it's one of the wires on the shifter to one of the pins under the dash somewhere...