In this engine build I used a gasket in the oil housing and it covered this hole.http://i1137.photobucket.com/albums/...99/007-5-1.jpg Upon removing this housing the gasket I installed was sucked into this area and deformed so as to allow the oil to move past the gasket.
The Main journal bearings look like this.http://i1137.photobucket.com/albums/...99/008-5-1.jpg This block was not hot tanked. Any help with this gasket question? Here is a picture of the gasket in place.http://i1137.photobucket.com/albums/...99/006-6-1.jpg |
All times are GMT -5. The time now is 12:06 AM. |
© 2024 MH Sub I, LLC dba Internet Brands