B&M Trans cooler mounting
 

I know this has been covered and I have searched a lot. I'm thinking about installing a B&M Supercooler for my transmission. I've seen a lot of ppl install them and mount them with the lines facing down. I searched and found the instructions from B&M and they say to not mount them this way.

So I'm just wondering for those of you that have it installed this way have you had any problems or anything? Here is the link to their instructions saying not to install it that way.

http://bmracing.com/wp-bnmcont/uploa...er_techdoc.pdf

The instructions on the 70255 supercooler I got didn't say anything about the inlet/outlets facing down.
Attachment 32749

What I do know is that the crappy regular hose clamps they supplied blew off while I was at a light. I replaced them with fuel injection clamps that have a nut & bolt assembly to tighten them. Thankfully I was only a few blocks from an auto parts place I deal with.

Attachment 32750