Stuck in 4HI
#1
Stuck in 4HI
I went off roading this morning with my brother and soon realized I had a 4WD issue. I was going in and our of 4HI to 4LO with no issues for about 2 hours.
After being in 4HI for a while I went to put it in 4LO to get up a hill and the button light flashed and didn't engage. After playing with it I tried puting it in 2WD, but that didn't work either. I looked at my vacuum lines and everything seems ok, but I don't really know what it could be.
Anybody have any ideas?
After being in 4HI for a while I went to put it in 4LO to get up a hill and the button light flashed and didn't engage. After playing with it I tried puting it in 2WD, but that didn't work either. I looked at my vacuum lines and everything seems ok, but I don't really know what it could be.
Anybody have any ideas?
#2
There's a dignostic/DIY thread for the front actuator somewhere on here. I've seen you you folks with your new highfallutin' vehicles, LOL, discussin' this problem quite a bit in the past.
I do think also that a bunch of mud packed in around the front half shafts can make it difficult for things to move around properly. ie engage/disengage.
I can't for the life of me remember where I saw it though.
I do think also that a bunch of mud packed in around the front half shafts can make it difficult for things to move around properly. ie engage/disengage.
I can't for the life of me remember where I saw it though.
Thread
Thread Starter
Forum
Replies
Last Post
jeffrozar
2nd Generation S-series (1995-2005) Tech
0
11-04-2011 10:08 AM
Alterac
2nd Generation S-series (1995-2005) Tech
5
08-25-2008 08:48 PM