I cant find trans temp.on mine..i looked?

 

Hmmm. This is the reason I got mine!

Do you have the UltraGauge MX or EM? The MX has the trans temp sensor reader. Here is a link to their manual page describing them.
https://ultra-gauge.com/ultragauge/s...Supplement.pdf

 

Dreaded P0300 code.

New cap, rotor, plugs, and wires later....no code. The wife even gave me a hand!

 

New distributor....i replaced everything and finally, and new distributor fixed it. I was lucky enough to have a buddy with an Jimmy who needed the new cap ,rotor , and camshaft sensor. So at least i didnt lose all my money.

 

Repainted above the door and installed a set of window shades. I vinyl covered them so I can spot the Blazer in a parking lot. We'll see...

 

This was yesterday but I finally got around to installing the extra rear floor liner that will go over the folded down rear seats.


The new part that I had to cut to shape around the front of the wheel wells and into which I cut notches for the head rest rods.


The rear part of the floor protector. I cut the front one so that it would extend under the rear one by about 5".

 

I ordered the dynomax super turbo catback exhaust system got it installed yesterday was pretty simple had to use some high temp gasket maker at the flange cause it never seals right without it.


All installed

Old bottle coming off

Abit of size difference
Went to take a picture of my cv axle for someone and saw a puddle and everything soaked turns out my rough country shocks are blown so far just the passenger side but I knew it was coming as they are 3 years old now and almost 90k km on them so will be ordering new shocks for front and rear
All that’s wet is fluid from the shock

 

That's why I try not to look under my Blazer unless I HAVE to... always find something else that needs fixed lol

 

Someone asked about cv angles with a lift kit so I had to take a pic to show mine and noticed on the ground a small super fresh puddle directly at the bottom of the control and so I followed the fluid hoping it wasn’t an axle seal and it’s the damn shocks but people have said the rc ones that come with the kit suck. I’m lucky I got 3 years out of them and plenty of abuse

 

Be glad it was not an axle seal! I have superlift shocks on my front end and they seem to be doing ok. I was on a budget at the time so I'll be upgrading to better ones when these go. I did mine 4 years ago so I guess mine have lasted a good amount in comparison. LOL