what have you gotten done on your blazer today?
#6702
09-04-2012, 12:59 PM
about 160 for everything (including a extra set of tails to cut up) (LED's circuit boards, wires, resistors, voltage regulators, capacitors)
The 3rd brake light was only 2.50 at upull, trailer hitch was pre built as well from amazon for like 30
The 3rd brake light was only 2.50 at upull, trailer hitch was pre built as well from amazon for like 30
#6704
09-04-2012, 03:05 PM
Solved the issue with the 4WD, was a stuck solenoid above the engine. But found a busted motor mount, driver side. Great fun in the sun. Still need to get under it and replace the pinion seal on the back axle
#6705
09-04-2012, 03:26 PM
Originally Posted by richphotos
about 160 for everything (including a extra set of tails to cut up) (LED's circuit boards, wires, resistors, voltage regulators, capacitors)
The 3rd brake light was only 2.50 at upull, trailer hitch was pre built as well from amazon for like 30
The 3rd brake light was only 2.50 at upull, trailer hitch was pre built as well from amazon for like 30
Originally Posted by dbshortwave
Solved the issue with the 4WD, was a stuck solenoid above the engine. But found a busted motor mount, driver side. Great fun in the sun. Still need to get under it and replace the pinion seal on the back axle
#6706
09-04-2012, 03:29 PM
Chris he ran a wire to the brake switch.. Because if you tap into the brake light wire... it will blink with the blinker.
#6708
09-04-2012, 04:05 PM
What Gio said, I tapped into the wiper motor ground, and then ran the power wire all the way up to the brake light switch, about a half hour-45 minute job.
#6709
09-04-2012, 06:22 PM
Originally Posted by dbshortwave
well.. went camping this past weekend, needed to put my jimmy in 4 Hi and found that the front axle isn't engaging. I'm not sure if I'm dealing with a stuck cable, vacuum lines (if its vacuum powered) or the motor for the actuator is dead... I hear the transfer case locking in but the front isn't, so I get an error flash on the dash buttons all but 2 Hi. Gotta get that fixed before the snow fly's
#6710
09-04-2012, 06:56 PM
Finally took mine out into some trails. Rained hard here, made the trails much more fun! Got all dirty then hosed everything off. 2 GO pro cameras, one on the front of my truck and one on the back of a buddy in front of me. Cant wait to edit the video and post it up.
