what have you gotten done on your blazer today?
#6811
Did brakes and rotors the other day,Much betta! but my pedal still has a inch of play before brakes engage decently. I guess il try bleeding em,but im starting to think its play in the master cylinder since its always had that bit of travel.
#6812
My throttle body had a restrictor cup riveted and fused to the throttle blade......all i did was cut away the cup part and left the flat fused part still attached to the blade and made it nice and flat to the profile of the blade........and leave the rivet still on it.......its NOT a good idea to remove the rivet as you will end up with an extra hole in the blade which will upset the idling.......the blade already has a specific size hole in it for stable idling to go with the tune ..........this mod helps with low to mid throttling around town...a noticable improvement
My wife states "made driving around town a whole lot easier and better with good response when she needed it".
My wife states "made driving around town a whole lot easier and better with good response when she needed it".
Welcome to the forum!
#6814
Cheers Franco
The fuel economy had basically stayed the same with that mod on the throttle body, it just got to speed easier and quicker. I am currently about to start altering the tune when i fit up a cold air intake. The other day i uploaded the tune from the vehicle to my laptop, and after looking through it i noticed that "Lean Cruise" is not currently activated and switched off. So after i finish remapping my tune and do economy comparisons with the stock tune (which i greatly believe will give more power and better economy) i will activate the "Lean cruise" section of the tune and do more tests........all this tuning and testing i will be doing will be done using 95 RON octane which is in the middle of our low and high octane fuels available here in New Zealand.
Regards Scotty
The fuel economy had basically stayed the same with that mod on the throttle body, it just got to speed easier and quicker. I am currently about to start altering the tune when i fit up a cold air intake. The other day i uploaded the tune from the vehicle to my laptop, and after looking through it i noticed that "Lean Cruise" is not currently activated and switched off. So after i finish remapping my tune and do economy comparisons with the stock tune (which i greatly believe will give more power and better economy) i will activate the "Lean cruise" section of the tune and do more tests........all this tuning and testing i will be doing will be done using 95 RON octane which is in the middle of our low and high octane fuels available here in New Zealand.
Regards Scotty
#6817
Got all my parts in a few days ago: ALL engine gaskets, Melling h/v oil pump (to make up for not installing new bearings), screen, steel shaft, and a set of brass freeze plugs.
Project is taking longer than normal, because I've got a bit sidetracked here with a TON of work I've put off for far too long now ...
Project is taking longer than normal, because I've got a bit sidetracked here with a TON of work I've put off for far too long now ...
#6818
Finally all the body rust is repaired, paint is completed and we are done. Also under-body sprayed with rust-mort and undercoating. Three coats of paint and 4 of clear coating. Lots of sanding and rubbing compound to fix do it your self issues. Updated the look removing the wheel well chrome and pinstripe. The 97 Blazer looks good. Xm tuner next.