need a little help
 

I have a 1994 4door 4wd s-10 blazer and Im about to do a sfa swap. I have a set of axles from a jeep cherokee. The front axle is already set up with a 3-link, coil springs, and all the connected parts (sway bar etc.). I'm trying to find out if anyone has done a similar swap and has any suggestions or better yet pictures of how they did the swap. Any help at all would be great.
Im planning on a set of 35', 15.5' wide tires, maybe Toyo's since they ride good on the road and off. And probably am gonna go about 8' up with it. Also, does anyone know where I can get new driveshafts made without dropping ridiculous money on them?

Thanks again, Greg

RE: need a little help
 

I hope the rear isnt a dana 35