Quick Question
#1
07-23-2006 | 09:45 PM
Thread Starter
Joined: Jul 2006
Posts: 19
Quick Question
Im looking to remove the molding and was wondering what you guys used to fill in the holes on the front bumper and side caps. Thanks
#2
07-23-2006 | 09:51 PM
BF Veteran
Joined: Feb 2006
Posts: 2,654
From: Baltimore, MD
RE: Quick Question
best best would to probably bond-o it
#3
07-23-2006 | 09:59 PM
RE: Quick Question
If you're going to repaint it anyway, I would weld the holes shut.
IIRC, the bumper has a recess for the molding. If that is the case, then you'd have to smooth it out for it to look right. If not, just disregard.
IIRC, the bumper has a recess for the molding. If that is the case, then you'd have to smooth it out for it to look right. If not, just disregard.
#4
07-23-2006 | 10:09 PM
Thread Starter
Joined: Jul 2006
Posts: 19
RE: Quick Question
It's recessed on the side caps so would it be easyer just to get new side caps...and how hard is bond-o-ing it bc i can't weld so that seems like the way to go
#5
07-24-2006 | 01:51 AM
Joined: Nov 2005
Posts: 251
From:
RE: Quick Question
It's probably easier and cheaper just to get a new front bumper without the holes
#6
07-30-2006 | 03:43 AM
Retired Super Moderator
Joined: Apr 2006
Posts: 2,094
From: The spec between the moon and the sun
RE: Quick Question
I was thinking that... to get another bumper... wasnt sure to say it. might be easier.
Thread
Thread Starter
Forum
Replies
Last Post