Repair Cost? Quarters by rear wheel well
#11
Im a little late here butt will throw in a few things. However you do it i would butt the new panel to the old metal with welding magnets. (pretty cheap for a set at horbor freight) as opposed to flanges.. flanges you will have a pretty high build up of filler to blend it in to where it looks right. I am getting ready to do both sides of my 95 and got my panels for 88.00 a panel. I am going to butt weld my panels in with them being held flush to the existing metal with the magnets.
Be really sure you go down to metal far enough around the rust to get to good metal. If you dont you will be doing this again soon..(made that mistake when i didnt know what i was doing)..
Good luck and post pics of the truck when finished.
Rick
Be really sure you go down to metal far enough around the rust to get to good metal. If you dont you will be doing this again soon..(made that mistake when i didnt know what i was doing)..
Good luck and post pics of the truck when finished.
Rick
Thread
Thread Starter
Forum
Replies
Last Post
er0ck273
Paint, Body, & Interior
28
08-30-2014 09:21 PM
bobby099
Engine & Transmission
7
03-20-2012 07:13 PM
mikeinwi
2nd Generation S-series (1995-2005) Tech
24
05-29-2009 12:04 PM