Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Grandpaswagon
Showing results 1 to 30 of 30
Search took 0.01 seconds.
Forum: Engine & Transmission
01-28-2018, 04:06 PM
Replies: 13
Views: 1,637
Posted By Grandpaswagon

Not trying to stir a pot here or anything, but...

Not trying to stir a pot here or anything, but emission devices are federally mandated and removing any of them is against federal laws and regulations.

Some states and local jurisdictions test...
Forum: 2nd Generation S-series (1995-2005) Tech
07-26-2016, 06:59 PM
Replies: 4
Views: 476
Posted By Grandpaswagon

Don't be surprised if there are more leaking...

Don't be surprised if there are more leaking orings than just that one. The truck is about 20 years old now, and if the system has ever been apart and the old seals reused, they may all need to be...
Forum: 2nd Generation S-series (1995-2005) Tech
07-06-2016, 10:53 AM
Replies: 12
Views: 2,118
Posted By Grandpaswagon

So, are you saying that the AC clutch is not...

So, are you saying that the AC clutch is not engaged when it blows warm air?

If that is the case, there are several potential problems, ranging from an improper refrigerant charge, to a bad...
Forum: 2nd Generation S-series (1995-2005) Tech
12-16-2015, 11:58 AM
Replies: 20
Views: 1,470
Posted By Grandpaswagon

I think that if you feel confident to swap all...

I think that if you feel confident to swap all the body panels, and take the time to get them all lined up correctly, then you have requisite knowledge, tools, and time to swap a transmission.
...
Forum: 2nd Generation S-series (1995-2005) Tech
08-21-2015, 11:31 AM
Replies: 4
Views: 1,001
Posted By Grandpaswagon

I replaced my ignition switch a couple months...

I replaced my ignition switch a couple months back. For similar problems as you described, transmission going in to limp mode.

My dash worked fine when ever my transmission problems would flair...
Forum: 2nd Generation S-series (1995-2005) Tech
06-25-2015, 12:22 PM
Replies: 33
Views: 7,788
Posted By Grandpaswagon

Bought a compressor and dryer for my '94 Camaro...

Bought a compressor and dryer for my '94 Camaro from this outfit a couple years ago. Still works great.


http://www.discountacparts.com/
Forum: 2nd Generation S-series (1995-2005) Tech
06-06-2015, 09:46 AM
Replies: 12
Views: 1,524
Posted By Grandpaswagon

You can always buy a cheap Chinese ignition...

You can always buy a cheap Chinese ignition switch. It won't be the quality of an OEM one, but for $25-35 bucks, it can give you peace of mind.


I just replaced my ignition switch. Mine would...
Forum: 2nd Generation S-series (1995-2005) Tech
05-31-2015, 06:36 PM
Replies: 14
Views: 4,042
Posted By Grandpaswagon

Without having the truck in the shop in front of...

Without having the truck in the shop in front of me, it is hard to tell.

I would start with voltage measurements and wiggle the fuse and switch and all other connectors while taking the...
Forum: 2nd Generation S-series (1995-2005) Tech
05-29-2015, 10:22 PM
Replies: 5
Views: 1,888
Posted By Grandpaswagon

Reverse drill bit, easy out or grind the heads...

Reverse drill bit, easy out or grind the heads off with a dremel. But you need to have the dizzy out of the truck to do any of the above.


Get your engine at TDC on the #1 compression stroke...
Forum: 2nd Generation S-series (1995-2005) Tech
05-29-2015, 10:02 PM
Replies: 14
Views: 4,042
Posted By Grandpaswagon

Does no air come out of the vents, or no COLD air...

Does no air come out of the vents, or no COLD air come out? If no air at all comes out, you may have a problem with your blower motor, or blower motor resistor. Of course if it blowing out of the...
Forum: 2nd Generation S-series (1995-2005) Tech
05-29-2015, 09:54 PM
Replies: 6
Views: 3,294
Posted By Grandpaswagon

The pressures for both the low side and high side...

The pressures for both the low side and high side are dependent on ambient air temps. You will need a set of AC gauges to get read your pressures. Those cans of R-134 at the parts store with a...
Forum: 2nd Generation S-series (1995-2005) Tech
05-29-2015, 09:46 PM
Replies: 7
Views: 4,866
Posted By Grandpaswagon

AC really isn't as hard as a lot of people think....

AC really isn't as hard as a lot of people think. You just have to know that it is a closed and sealed system.


To work on it yourself, you will need a set of AC gauges, and a vacuum pump at a...
Forum: 2nd Generation S-series (1995-2005) Tech
05-29-2015, 09:28 PM
Replies: 2
Views: 650
Posted By Grandpaswagon

Oh, I forgot to thank everyone for the help on...

Oh, I forgot to thank everyone for the help on diagnosing and replacing my ignition switch. Just a few weeks ago I was driving home when I noticed that she really didn't like starting for a dead...
Forum: 2nd Generation S-series (1995-2005) Tech
05-29-2015, 09:21 PM
Replies: 2
Views: 650
Posted By Grandpaswagon

My Odyssey

Hey guys. Been lurking for a long time, thought that I would post a big thank you for all of your help with my 1997 Blazer.:icon_smile:


I bought it from a rural airport in February 2014, with...
Forum: Engine & Transmission
03-28-2015, 04:59 PM
Replies: 9
Views: 15,747
Posted By Grandpaswagon

I know this thread is a little dated, but I am...

I know this thread is a little dated, but I am wondering if you completely solved the problems you were having with the new ignition switch, or if they all started coming back after a few days?
Forum: 2nd Generation S-series (1995-2005) Tech
01-03-2015, 07:13 PM
Replies: 7
Views: 1,808
Posted By Grandpaswagon

I know this is an old thread, but did you ever...

I know this is an old thread, but did you ever get this sorted out? If so, what was the final repair?
Forum: 2nd Generation S-series (1995-2005) Tech
04-08-2014, 01:52 PM
Replies: 7
Views: 1,808
Posted By Grandpaswagon

Make sure you disconnect the battery before you...

Make sure you disconnect the battery before you touch those sensors. It would be a very expensive mistake to have the airbags deploy.
Forum: 2nd Generation S-series (1995-2005) Tech
04-08-2014, 01:49 PM
Replies: 11
Views: 6,488
Posted By Grandpaswagon

I had a Jeep several years ago that the exact...

I had a Jeep several years ago that the exact same thing happened. I replaced the tank and within a few weeks, my new tank was also caved in. Then I knew that something more was happening and...
Forum: 2nd Generation S-series (1995-2005) Tech
04-06-2014, 02:19 PM
Replies: 7
Views: 1,808
Posted By Grandpaswagon

The airbag module is definitely behind the...

The airbag module is definitely behind the passenger kick panel. I am not sure where the sensors are located. Although I read that sometimes the connections behind the front bumper get dirty and...
Forum: 2nd Generation S-series (1995-2005) Tech
03-24-2014, 11:40 AM
Replies: 8
Views: 1,794
Posted By Grandpaswagon

Before you start soldering on the 4WD switch,...

Before you start soldering on the 4WD switch, Check for your 12V at the TCCM, which is located to the left of the ashtray behind the lower dash. It is a pain to get to, but I had the exact same...
Forum: 2nd Generation S-series (1995-2005) Tech
03-22-2014, 05:10 PM
Replies: 3
Views: 606
Posted By Grandpaswagon

Holy Moly. You answered your own questions in...

Holy Moly. You answered your own questions in record time.
Forum: 2nd Generation S-series (1995-2005) Tech
03-15-2014, 12:47 AM
Replies: 9
Views: 1,267
Posted By Grandpaswagon

I figured mine out and it was a door switch also....

I figured mine out and it was a door switch also. But not the front doors. It was the rear door on the driver side. The switch wasn't working, but I gave it a shot of electric contact cleaner and...
Forum: 2nd Generation S-series (1995-2005) Tech
03-12-2014, 12:35 AM
Replies: 6
Views: 12,542
Posted By Grandpaswagon

Thank you for the info. Now that I know what a...

Thank you for the info. Now that I know what a short and open cause, I can give that a try in the next couple days and see if it is in the sensor or the wiring.
Forum: 2nd Generation S-series (1995-2005) Tech
03-11-2014, 04:14 PM
Replies: 6
Views: 12,542
Posted By Grandpaswagon

Oil pressure gauge pegged

1997 Chevy Blazer, 4.3L, Auto, "W" VIN code.

What is the most likely cause for the oil pressure gauge to be pegged max at all times (ignition on, off, cranking, running)? Should I be looking for...
Forum: Paint, Body, & Interior
03-02-2014, 08:38 PM
Replies: 6
Views: 820
Posted By Grandpaswagon

Wow. With a list like that for replacement...

Wow. With a list like that for replacement parts, you are going to have a lot more into the truck then it will be worth when you are done. That is a lot of cutting, fitting, welding and filling to...
Forum: 2nd Generation S-series (1995-2005) Tech
02-28-2014, 12:31 AM
Replies: 7
Views: 7,300
Posted By Grandpaswagon

Did you ever figure out why your lights wouldn't...

Did you ever figure out why your lights wouldn't turn off?
Forum: 2nd Generation S-series (1995-2005) Tech
02-23-2014, 03:35 PM
Replies: 9
Views: 1,267
Posted By Grandpaswagon

To the best of my knowledge, there is no...

To the best of my knowledge, there is no underhood fuse block on a '97 Chevy Blazer.
Forum: 2nd Generation S-series (1995-2005) Tech
02-23-2014, 12:13 PM
Replies: 4
Views: 3,413
Posted By Grandpaswagon

Thank you for the reply. I will check under the...

Thank you for the reply. I will check under the hood for a possible break in the wiring. I will also watch eBay for a GM shop manual. Last thing I want to do is start hacking into the wiring loom...
Forum: 2nd Generation S-series (1995-2005) Tech
02-22-2014, 08:32 PM
Replies: 9
Views: 1,267
Posted By Grandpaswagon

What was the problem? I am having the exact same...

What was the problem? I am having the exact same issue with my '97 Blazer (interior lights won't turn off).
Forum: 2nd Generation S-series (1995-2005) Tech
02-22-2014, 03:10 PM
Replies: 4
Views: 3,413
Posted By Grandpaswagon

1997 BLAZER NO 4WD (Electrical Problem)

I just got a 1997 Chevy Blazer with the switch on the dash near the center vents to select 2WD/4HI/4LO.

None of the lights on the selector switch work and the 4WD does not work either.

...
Showing results 1 to 30 of 30


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands