Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Tubais
Showing results 1 to 35 of 35
Search took 0.01 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
01-09-2012, 09:02 AM
Replies: 0
Views: 657
Posted By Tubais

IAC motor ??'s

Yesterday after a extended period at 75 mph on the freeway. I pulled off to get gas and all of a sudden my blazer was idling at 1500 rpm's... So i searched the forum and found out about cleaning them...
Forum: General Chat
01-03-2012, 08:46 AM
Replies: 4
Views: 863
Posted By Tubais

I know its running way too cold and thanks for...

I know its running way too cold and thanks for the replies..
I was looking under the hood and found the connector for the knock sensor but can't find the sensor.. I went through the locator book...
Forum: General Chat
01-01-2012, 11:20 AM
Replies: 4
Views: 863
Posted By Tubais

sorry was trying to put this in gen 1 forum

sorry was trying to put this in gen 1 forum
Forum: Engine & Transmission
01-01-2012, 12:01 AM
Replies: 9
Views: 7,211
Posted By Tubais

Have you considered just putting new bearings in...

Have you considered just putting new bearings in it? if it runs fine otherwise i'd drop the front diff and pull the pan... Just another option an way less time then swapping a engine
Forum: General Chat
12-31-2011, 01:21 PM
Replies: 4
Views: 863
Posted By Tubais

93 astro 4.3 in a toyota!!!!

Hello all hope it is ok i post this...

Anyways i have this rig and it has a code for the electronic spark module what I've found is that there is good grounds to the body and the battery, however...
Forum: Paint, Body, & Interior
12-26-2011, 11:10 AM
Replies: 3
Views: 6,993
Posted By Tubais

Not saying it is the "right way" but i just...

Not saying it is the "right way" but i just installed the bushings and it was enough to take out the slack
Forum: 2nd Generation S-series (1995-2005) Tech
12-11-2011, 05:03 PM
Replies: 5
Views: 6,112
Posted By Tubais

How do you pull the glove box??? Looks like it is...

How do you pull the glove box??? Looks like it is molded into the dash, At least on my 95.. I took the door off and couldn't find anymore screws to remove it..
Forum: 2nd Generation S-series (1995-2005) Tech
12-11-2011, 04:57 PM
Replies: 8
Views: 2,402
Posted By Tubais

95 96 97 Chevy S10 Blazer Climate Control OEM |...

95 96 97 Chevy S10 Blazer Climate Control OEM | eBay...
Forum: 2nd Generation S-series (1995-2005) Tech
12-02-2011, 03:57 PM
Replies: 11
Views: 11,652
Posted By Tubais

Just curious is all... I have heard of smoke...

Just curious is all... I have heard of smoke testing intake systems just never the injectors. Sounds now like a intake leak that should be addressed and could cause all the symptoms mentioned......
Forum: 2nd Generation S-series (1995-2005) Tech
12-02-2011, 09:57 AM
Replies: 11
Views: 11,652
Posted By Tubais

Just curious how can you smoke test the injector...

Just curious how can you smoke test the injector system? Just trying to wrap my head around it?
Forum: 1st Generation S-series (1983-1994) Tech
12-01-2011, 08:32 PM
Replies: 3
Views: 3,410
Posted By Tubais

i would charge a hour.. in my shop

i would charge a hour.. in my shop
Forum: 2nd Generation S-series (1995-2005) Tech
11-30-2011, 11:52 AM
Replies: 7
Views: 2,654
Posted By Tubais

maybe you blend doors aren't working? the other...

maybe you blend doors aren't working? the other options are blown head gaskets.. are you losing water?
Forum: Sights N Sounds
11-28-2011, 09:12 AM
Replies: 471
Views: 60,858
Posted By Tubais

my beater

Mobile Photobucket (http://m67.photobucket.com/albumview/albums/tubais/100_2403.jpg.html)
Forum: Tires and Wheels
11-27-2011, 10:04 AM
Replies: 4
Views: 2,592
Posted By Tubais

I'd take one for a drive to the tire store, and...

I'd take one for a drive to the tire store, and see what they say
Forum: 2nd Generation S-series (1995-2005) Tech
11-27-2011, 09:59 AM
Replies: 10
Views: 1,662
Posted By Tubais

could be fuel pump relay in the glove box... it...

could be fuel pump relay in the glove box... it sits at a weird angle
Forum: Engine & Transmission
11-24-2011, 01:26 PM
Replies: 2
Views: 1,478
Posted By Tubais

if its a throttle body they are notorious for...

if its a throttle body they are notorious for sucking the gasket causing idle and decel issues
Forum: 2nd Generation S-series (1995-2005) Tech
11-22-2011, 06:24 PM
Replies: 3
Views: 2,468
Posted By Tubais

atf or oil? either way the tranny has to come...

atf or oil? either way the tranny has to come out....
Forum: Engine & Transmission
11-22-2011, 06:22 PM
Replies: 21
Views: 4,619
Posted By Tubais

I would replace it too if you noticed more...

I would replace it too if you noticed more leaking!!! Coolant system is pretty important in my book..
my 2cts
Forum: 2nd Generation S-series (1995-2005) Tech
11-21-2011, 09:19 PM
Replies: 14
Views: 7,874
Posted By Tubais

the smell won't go away completely and the leak...

the smell won't go away completely and the leak will eventually get larger
Forum: 2nd Generation S-series (1995-2005) Tech
11-20-2011, 03:53 PM
Replies: 0
Views: 529
Posted By Tubais

fuel ?'s

After searching I'm trying to understand the fuel vents... I replaced the fuel pump last night and filled it up today and it started gushing fuel...

I got under the car and i had forgot to hook up...
Forum: General Chat
11-20-2011, 03:08 PM
Replies: 13,741
Views: 1,064,631
Posted By Tubais

fuel pump

gonna do it again cause i don't think the oring seated and leaks like crazy since i just filled it
:icon_dopey:
Forum: 2nd Generation S-series (1995-2005) Tech
11-20-2011, 11:35 AM
Replies: 0
Views: 1,469
Posted By Tubais

vacuum leaks

95 blazer 4x4

Everything i touch on this blazer shows me new problems!!!!! I did the transfer case seal, Found that vacuum end of the switch on top of the transfer case would turn in the switch...
Forum: Engine & Transmission
11-16-2011, 11:25 AM
Replies: 10
Views: 11,187
Posted By Tubais

you bleed it just like brakes.. 2 people pump and...

you bleed it just like brakes.. 2 people pump and hold it down and open the bleeder.. after the pressure is off close the bleeder. might have to reach down and pull the pedal up by hand a few times...
Forum: 2nd Generation S-series (1995-2005) Tech
11-13-2011, 08:45 PM
Replies: 57
Views: 7,377
Posted By Tubais

just wondering if the timing cover was replaced?...

just wondering if the timing cover was replaced? aren't they plastic and recommended changing with the chain... i had a suburban that wouldn't run and the air gap to the reluctor was to big and if i...
Forum: 2nd Generation S-series (1995-2005) Tech
11-12-2011, 10:48 AM
Replies: 15
Views: 1,173
Posted By Tubais

have you cleaned your egr or swapped it out with...

have you cleaned your egr or swapped it out with another from the mud toy? check back pressure in the exhaust? imho the dist caps can look fine and still be a problem and just cross fire inside... i...
Forum: 2nd Generation S-series (1995-2005) Tech
11-10-2011, 07:57 PM
Replies: 15
Views: 1,317
Posted By Tubais

ok now i get it... Thank you.. The explanation...

ok now i get it... Thank you.. The explanation make devising a tester much simpler too... Is there any chance of damage to the pump if energized too long?

Thx Terry
Forum: 2nd Generation S-series (1995-2005) Tech
11-10-2011, 06:33 PM
Replies: 15
Views: 1,317
Posted By Tubais

Ok i get that... And should be able to maintain...

Ok i get that... And should be able to maintain it no matter what the engine demands... What about the bleed down test on the 95 blazer?

I there a second regulator in the return line or in the...
Forum: 2nd Generation S-series (1995-2005) Tech
11-10-2011, 05:46 PM
Replies: 15
Views: 1,317
Posted By Tubais

not sure if this is legal but wanting to keep...

not sure if this is legal but wanting to keep these seperate...

hooked up the exhaust analyzer hhc was over 4000 co over 5 afr 18/1...

just cause i decided to pull off the egr and it was...
Forum: 2nd Generation S-series (1995-2005) Tech
11-09-2011, 05:49 PM
Replies: 15
Views: 1,317
Posted By Tubais

i installed it in place.. put the old one back in...

i installed it in place.. put the old one back in it held pressure stayed at 61psi for 10 minute then poof it dropped to twenty now won't hold pressure either.. something seems weird... So can the...
Forum: 2nd Generation S-series (1995-2005) Tech
11-09-2011, 05:09 PM
Replies: 15
Views: 1,317
Posted By Tubais

installed new regulator now it won't hold 55psi...

installed new regulator now it won't hold 55psi for 30 seconds!!! crap before it held 56.. any way to tell if its the componet its self ?
Forum: 2nd Generation S-series (1995-2005) Tech
11-09-2011, 12:07 PM
Replies: 15
Views: 1,317
Posted By Tubais

Sorry sir... Think i'm on the right track of...

Sorry sir... Think i'm on the right track of thinking?
Forum: 2nd Generation S-series (1995-2005) Tech
11-09-2011, 11:28 AM
Replies: 15
Views: 1,317
Posted By Tubais

hmmm back pressure is within specs.. was thinking...

hmmm back pressure is within specs.. was thinking that it was just rich, or was hoping anyways after a 30 mile drive @ 75mph
Forum: 2nd Generation S-series (1995-2005) Tech
11-09-2011, 11:07 AM
Replies: 5
Views: 1,252
Posted By Tubais

The blazer i just bought has a fuel leak also......

The blazer i just bought has a fuel leak also... what i found was the vent leaking when i over filled it.. My tank is metal so it is replaceable not sure about yours..
good luck
Forum: 2nd Generation S-series (1995-2005) Tech
11-09-2011, 10:52 AM
Replies: 15
Views: 1,317
Posted By Tubais

New here 95 blazer owner

My first post here and thanks for letting me join..
I bought a 95 blazer and so far it feels like a error.. I have been searching the forum for 3 days before this post and have found alot of...
Forum: Engine & Transmission
11-06-2011, 07:53 PM
Replies: 12
Views: 24,856
Posted By Tubais

have you noticed that if you hold the throttle...

have you noticed that if you hold the throttle open it starts easier? my blazer is like that..
Showing results 1 to 35 of 35


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands