Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Antne
Showing results 1 to 20 of 20
Search took 0.00 seconds.
Forum: Engine & Transmission
04-10-2014, 11:33 AM
Replies: 7
Views: 4,492
Posted By Antne

Hey Tony1987mustang, did you ever figure out...

Hey Tony1987mustang, did you ever figure out this issue with the stalling? I also have a 95 and was stalling as well and had the exact same codes. I haven't been able to take it in anywhere and I...
Forum: Engine & Transmission
03-11-2014, 03:53 AM
Replies: 4
Views: 1,939
Posted By Antne

Yes Start With The fuel Pressure Test, Then I...

Yes Start With The fuel Pressure Test, Then I Would Do A Compression Test As Well. My 95 Was recently Running The Same WaY ChangedMost Of The Same Parts. Fuel PrEssure Was Good But After A...
Forum: 2nd Generation S-series (1995-2005) Tech
03-04-2014, 03:28 AM
Replies: 11
Views: 7,639
Posted By Antne

Sorry about the separate threads. After 3 days...

Sorry about the separate threads. After 3 days with no response on the ignition, I went ahead and started removing the steering wheel and figured it was another subject so started a new thread. ...
Forum: 2nd Generation S-series (1995-2005) Tech
03-03-2014, 11:47 PM
Replies: 11
Views: 7,639
Posted By Antne

Trying to remove lock plate on steering wheel

Okay still working on my stuck ignition lock cylinder that does not turn. I have started on taking off the steering wheel in order to get to the two bolts that hold the section of the steering...
Forum: 2nd Generation S-series (1995-2005) Tech
03-03-2014, 11:39 PM
Replies: 11
Views: 7,639
Posted By Antne

got it! needed a punch stick that was small...

got it! needed a punch stick that was small enough to fit inside the hole and gave it a good whack with a rubber mallet and pushed it out.
Forum: 2nd Generation S-series (1995-2005) Tech
03-03-2014, 11:21 PM
Replies: 11
Views: 7,639
Posted By Antne

Thanks for the reply, I did not try shift cable. ...

Thanks for the reply, I did not try shift cable. I am not familiar with it. where would I start to look? would it be the cable that hooks on to the neutral safety switch? do I start with it there...
Forum: 2nd Generation S-series (1995-2005) Tech
03-03-2014, 06:10 PM
Replies: 11
Views: 7,639
Posted By Antne

Need help removing airbag on 95 blazer

I am attempting to remove the steering wheel on my 95 blazer. However, I am already having issues with removing the airbag on it. I am unable to get it off of the steering wheel.

Before anyone...
Forum: 2nd Generation S-series (1995-2005) Tech
03-03-2014, 04:55 PM
Replies: 11
Views: 7,639
Posted By Antne

really nothing from anyone? Well since then I...

really nothing from anyone? Well since then I have decided to remove the steering wheel in order to get to the two screws to take the portion of the column that holds the ignition lock and ignition...
Forum: 2nd Generation S-series (1995-2005) Tech
02-28-2014, 11:49 AM
Replies: 11
Views: 7,639
Posted By Antne

95 Blazer Ignition Lock Cylinder Stuck

While replacing the ignition switch I removed the lock cylinder (dont know why I did - maybe because I replaced it with the switch last time). Anyhow, after putting the lock cylinder back in, it now...
Forum: Engine & Transmission
08-22-2013, 11:29 AM
Replies: 1
Views: 708
Posted By Antne

Hello Ruth, if you are still looking for a good...

Hello Ruth, if you are still looking for a good honest mechanic in Phoenix you should see the guys at 25th Street Automotive. Bill is owner . Very honest and straight forward shop - and I do...
Forum: 2nd Generation S-series (1995-2005) Tech
03-16-2013, 06:42 PM
Replies: 6
Views: 1,222
Posted By Antne

problem solved - thanks for the input

Thanks for the comments everyone. Not only did my car die but my computer took a dump as well. but is now up and running.
Spittybays: as I stated I did fix the dripping by replacing the fuel...
Forum: 2nd Generation S-series (1995-2005) Tech
03-14-2013, 12:53 AM
Replies: 6
Views: 1,222
Posted By Antne

so if it is the fuel pressure could it be that...

so if it is the fuel pressure could it be that the pump is needing to be replaced? I would think that it is the fuel pressure only because the fuel is not even passing the pressure valve nor going...
Forum: 2nd Generation S-series (1995-2005) Tech
03-13-2013, 06:25 PM
Replies: 6
Views: 1,222
Posted By Antne

95 wont start - fuel delivery issue

My 95 blazer recently died on the freeway, just stopped running and hasnt started since. After looking under the hood I noticed that the valve that is used to check the fuel pressure has gas coming...
Forum: 2nd Generation S-series (1995-2005) Tech
05-10-2012, 06:51 PM
Replies: 1
Views: 2,073
Posted By Antne

Anybody?

Anybody?
Forum: 2nd Generation S-series (1995-2005) Tech
05-08-2012, 08:12 PM
Replies: 1
Views: 2,073
Posted By Antne

New VCM for 95 Blazer Now Wont start at all

I have been having a few problems with my blazer. Main problem is not starting. would start in morning to go to work. When start at lunchtime would have problems starting. It cranks but takes...
Forum: 2nd Generation S-series (1995-2005) Tech
08-21-2011, 06:39 PM
Replies: 0
Views: 547
Posted By Antne

a/c blows only when moving

My a/c only blows when the car is moving. It blows nice and cold, but once I stop, so does the air. Once I start moving and get a little speed the air starts blowing again. I am at a loss with...
Forum: 2nd Generation S-series (1995-2005) Tech
07-04-2011, 07:21 PM
Replies: 21
Views: 16,797
Posted By Antne

Try the relays. Had the same thing happen to me,...

Try the relays. Had the same thing happen to me, in addition to the blower motor not working on high. Both were the relay switches. With a voltage meter, power was going to relay but not to...
Forum: 2nd Generation S-series (1995-2005) Tech
07-08-2009, 01:43 AM
Replies: 18
Views: 7,489
Posted By Antne

I had simular problems about a year ago. Ended...

I had simular problems about a year ago. Ended up replacing the spider assembly. It was leaking gas into the upper manifold. Always smelled of gas and terrible gas mileage. I dont remember the...
Forum: 2nd Generation S-series (1995-2005) Tech
07-07-2009, 09:47 PM
Replies: 2
Views: 1,763
Posted By Antne

thanks for replying. I just printed out a page...

thanks for replying. I just printed out a page to a link that explains how to test to see if relay is getting power. Im going to try it out now. We'll see how it goes. Thanks again
Forum: 2nd Generation S-series (1995-2005) Tech
07-07-2009, 01:26 AM
Replies: 2
Views: 1,763
Posted By Antne

A/C Wont blow high

Last month the A/C in my 95 blazer stopped blowing when the setting was on high, but worked in all other settings.
I switched relays with others and even bought a new one but no change so I...
Showing results 1 to 20 of 20


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands