Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: Deatherage
Showing results 1 to 30 of 30
Search took 0.00 seconds.
Replies: 4
Views: 1,255
Posted By Deatherage

I bought all new switches from LMC Truck for...

I bought all new switches from LMC Truck for CHEAP!
I recommend replacing them if you are already in there. There's usually a good amount of oxidation inside the old switches by now.
Replies: 8
Views: 25,790
Posted By Deatherage

It throws a code right? Any idea when GM started...

It throws a code right? Any idea when GM started putting computers in these trucks? I think I found a Delco computer in the dash of my '82. It is not connected to anything. I think, if I'm not...
Replies: 7
Views: 2,541
Posted By Deatherage

Don't the Vortec heads have reverse flow coolant?...

Don't the Vortec heads have reverse flow coolant? I'm not sure from your post what setup you are running. Can you set Vortec heads on an 87-95 Block? Or older generation small blocks?
Replies: 7
Views: 872
Posted By Deatherage

Does it idle low? Do you have to use the...

Does it idle low?
Do you have to use the accellerator pedal to keep it idling?
When you are stopped and you take off, does it sputter as though it is starving for fuel?
Replies: 7
Views: 872
Posted By Deatherage

Does it hesitate or sputter on hard...

Does it hesitate or sputter on hard accelleration?
Does it run well once it's started?
Does it run well once the engine is warm?
Replies: 12
Views: 1,664
Posted By Deatherage

Performance and Efficiency...with the same tune...

Performance and Efficiency...with the same tune at the same time? When I got my K5 it had one on it along with a smog pump, EGR and the like.....the float was stuck (pouring gas out of the top) I...
Replies: 12
Views: 1,664
Posted By Deatherage

Dude, you run a Quad-J in your truck???? Do you...

Dude, you run a Quad-J in your truck???? Do you like it??
12-16-2010, 07:43 AM
Replies: 11
Views: 3,506
Posted By Deatherage

Sure hope they dont bump into anything with them!...

Sure hope they dont bump into anything with them! That would destroy 'em.
12-16-2010, 07:40 AM
Replies: 8
Views: 3,035
Posted By Deatherage

Never was a fan of the smaller Blazers, but...

Never was a fan of the smaller Blazers, but that's pretty cool. Sure looks like those people did it right! Good luck on yours! :)
12-15-2010, 09:32 AM
Replies: 2
Views: 1,439
Posted By Deatherage

Ive had mine down to the steel frame. you get a...

Ive had mine down to the steel frame. you get a lot more access when you remove the dash pad, gauge cluster, and the A.C. ducts. There are parts that are still hard to get to though.

As far as...
Forum: Shows & Clubs
12-15-2010, 09:30 AM
Replies: 37
Views: 7,196
Posted By Deatherage

I'm around Houston and want to know if anyone...

I'm around Houston and want to know if anyone else is too.
Replies: 9
Views: 1,005
Posted By Deatherage

Thats a tough question to answer without all of...

Thats a tough question to answer without all of the specifics. First, is your truck at a shop now? If so, then have they torn it down? If they have then what, specificly did they write it up for?...
Replies: 9
Views: 7,702
Posted By Deatherage

stupid question....lug nuts tight??

stupid question....lug nuts tight??
Replies: 4
Views: 8,249
Posted By Deatherage

Family Bar! I love it. I have never seen that...

Family Bar! I love it. I have never seen that option in that body style.

Mine came with the 1E50 Rear Roll Bar on the '82
It came with all kinds of crap, most of it gone, or useless by now.
...
Replies: 4
Views: 8,249
Posted By Deatherage

Factory Roll Bar

Has anyone here ever seen the factory-option roll bar. I have one, but have never seen another.
Replies: 8
Views: 2,268
Posted By Deatherage

They are on the left fender in front of the...

They are on the left fender in front of the firewall. I finally threw mine away after being tired of looking a it for 3 months on my garage floor. Mine came with all kinds of cool factory stuff.
Replies: 11
Views: 3,339
Posted By Deatherage

It makes me sick to think that your Blazer should...

It makes me sick to think that your Blazer should have to have an emissions test. My 82 is exempt from having to have an odometer reading on the title and Arizona if effing with you about the...
Replies: 0
Views: 738
Posted By Deatherage

Started my K5 today after letting it sit for 3 months

http://www.youtube.com/watch?v=6EfEYWYdlk8

http://www.youtube.com/watch?v=CSzbwSFYSQg
Replies: 6
Views: 885
Posted By Deatherage

When I installed my Edelbrock Performer 650 with...

When I installed my Edelbrock Performer 650 with electric choke, the choke was dangerously high..I got the same thing and thought I was going to blow my engine too.. if you have electric choke....try...
Replies: 1
Views: 2,050
Posted By Deatherage

PLEASE DONT USE IT IF YOU ARE NOT CERTAIN Its...

PLEASE DONT USE IT IF YOU ARE NOT CERTAIN
Its imperative that you have the right dipstick for your engine. a little shorter or a little longer changes the oil level and could mean the difference...
Replies: 2
Views: 785
Posted By Deatherage

I agree. LMC LMC LMC Ive spent...

I agree.

LMC
LMC
LMC


Ive spent thousands in the LMC catalog.....without this parts resource I wouldnt have bought the Blazer in the first place.
Replies: 8
Views: 2,380
Posted By Deatherage

My steering, too, is ridiculously light. U turns...

My steering, too, is ridiculously light. U turns with my little finger, I love it.
Just hard to drive at speed. No play in the wheel....goes straight down the road. Maybe I'm just not used to it.
Replies: 8
Views: 2,380
Posted By Deatherage

Looks ok....I'm stumped too. Maybe its just...

Looks ok....I'm stumped too.
Maybe its just old and Im not used to it?
How does yours drive? Does it feel comfortable?
Replies: 8
Views: 2,380
Posted By Deatherage

31 10.5 bfg at....40psi

31 10.5 bfg at....40psi
Replies: 8
Views: 2,380
Posted By Deatherage

Tighter than a frogs ass. It feels like the...

Tighter than a frogs ass.

It feels like the entire vehicle rocks back and forth like an anchored boat rocking from side to side, almost like lack of firmness in the suspension.
Replies: 8
Views: 2,380
Posted By Deatherage

'82 k5----all over the road

My '82 K5 is all over the road. I know it's short wheelbase, but it feels borderline dangerous, especially over bumpy roads. I'm running the dual front shock setup with a steering stabilizer, and all...
Replies: 4
Views: 5,465
Posted By Deatherage

K5 has 2 different setups for speedomoter cables....

K5 has 2 different setups for speedomoter cables.

2 piece (cruise control)
1 cable goes from the transmission or transfer case to the cruise control module. and the 2nd cable goes from the...
Forum: Builds
12-05-2010, 11:41 PM
Replies: 15
Views: 4,347
Posted By Deatherage

When I did my interior, I DREADED pulling up the...

When I did my interior, I DREADED pulling up the carpet. Once I finally got the nerve, I found all kinds of holes. I paid a bodyshop $700 to repair the holes, put in new steel, and re create the...
Forum: Builds
12-05-2010, 11:33 PM
Replies: 5
Views: 721
Posted By Deatherage

Do what I did and have the exhaust shop weld the...

Do what I did and have the exhaust shop weld the pipes straight to the headers. Sure you will have to cut them off, but they aren't going to leak.
Showing results 1 to 30 of 30


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands