Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: 00blazer13
Showing results 1 to 27 of 27
Search took 0.00 seconds.
Forum: Steering, Suspension & Drivetrain
01-18-2012, 07:06 PM
Replies: 9
Views: 4,618
Posted By 00blazer13

Update. Drained fluid, cleaned with brake...

Update. Drained fluid, cleaned with brake cleaner, refilled gear lube. So far almost a month and still looks clean. “not milky” Thank You.
Forum: Lighting & Electrical
12-20-2011, 08:39 PM
Replies: 3
Views: 1,219
Posted By 00blazer13

Does the hazard switch connect to the...

Does the hazard switch connect to the multifunction switch?
Forum: Lighting & Electrical
12-20-2011, 04:59 PM
Replies: 1
Views: 783
Posted By 00blazer13

gas gauge stuck at ¼

2000 s-10 4wd Ls. yes another issue. The gauge has been stuck on ¼ tank since I bought it. The low fuel light comes on near the right time. I have read the other issues with the gauge (stuck on full...
Forum: Lighting & Electrical
12-20-2011, 04:36 PM
Replies: 3
Views: 1,219
Posted By 00blazer13

no turn signals

2000 s-10 4wd ls. My hazard light switch was jammed since I bought the truck. I saw a post that said you can pull the switch out. I tried that, it popped up and I have hazard lights now and no turn...
Forum: Steering, Suspension & Drivetrain
12-20-2011, 10:21 AM
Replies: 9
Views: 4,618
Posted By 00blazer13

No river crossing at all. Not even much...

No river crossing at all. Not even much rain.Thank You for your replies and suggestion.
Forum: 2nd Generation S-series (1995-2005) Tech
12-20-2011, 12:28 AM
Replies: 23
Views: 56,120
Posted By 00blazer13

My .02 is the lim also. When he replaces the...

My .02 is the lim also. When he replaces the gaskets be sure to get the felpro brand. When I did mine I could only buy a kit that came with valve cover and upper intake manifold gaskets and some...
Forum: Steering, Suspension & Drivetrain
12-19-2011, 11:42 PM
Replies: 9
Views: 4,618
Posted By 00blazer13

Thanks! I will do that soon. Is there gear lube...

Thanks! I will do that soon. Is there gear lube you would recommend using? Instead of the Master craft GL5 80w-90. I noticed a small leak where the drive shaft goes into the front diff. Would water...
Forum: Steering, Suspension & Drivetrain
12-19-2011, 09:31 PM
Replies: 9
Views: 4,618
Posted By 00blazer13

Ok, i checked the correct vent hose and it is up...

Ok, i checked the correct vent hose and it is up next to the radiator, no damage on it and has a plastic cap. How else can water get into the front diff? And how much water would it possibly take to...
Forum: Steering, Suspension & Drivetrain
12-16-2011, 09:56 AM
Replies: 9
Views: 4,618
Posted By 00blazer13

Do you mean the coolant overflow vent hose? It...

Do you mean the coolant overflow vent hose? It hangs down past the axle tube. How would water get in there? Thanks for any help.
Forum: Tires and Wheels
12-13-2011, 04:47 PM
Replies: 4
Views: 1,206
Posted By 00blazer13

I got some info from other people on the...

I got some info from other people on the wranglers from a post I made. Search for goodyear wranglers?? I had some on my other truck and I noticed a few small slits radially. It looked like the...
Forum: Steering, Suspension & Drivetrain
12-13-2011, 04:28 PM
Replies: 9
Views: 4,618
Posted By 00blazer13

milky looking front diff fluid

I replaced both outer front shaft seals and bearings about 3 months ago. I also took apart the front diff because 4x4 was not working. Fixed it, replaced fluid, rechecked fluid level and now it looks...
Forum: Engine & Transmission
09-29-2011, 06:47 PM
Replies: 6
Views: 1,255
Posted By 00blazer13

Not a bad job if you have tools. I rented a ball...

Not a bad job if you have tools. I rented a ball joint separator. A pry bar and a thin piece of wood got my axle out. I don’t c paying a shop for this job. This is my first time doing this job. Ask...
Forum: Engine & Transmission
09-28-2011, 05:38 PM
Replies: 6
Views: 1,255
Posted By 00blazer13

Thanks, I got it apart.

Thanks, I got it apart.
Forum: Engine & Transmission
09-27-2011, 06:58 PM
Replies: 6
Views: 1,255
Posted By 00blazer13

front diff, I need help

2000 s10 blazer 4x4. Changing front diff outer shaft seal and bearings. Passenger side was leaking, so I am doing both sides. Is there a trick to getting the driver side shaft out of the diff case?...
Forum: Steering, Suspension & Drivetrain
09-26-2011, 06:39 PM
Replies: 5
Views: 2,761
Posted By 00blazer13

fluid in vacuum lines

Check your transfer case to see if it is overflowing with fluid. There is a seal between the transmission and transfer case that may be leaking. It will fill up transfer case with tranny fluid, then...
Forum: New Member Area
09-24-2011, 07:04 PM
Replies: 5
Views: 564
Posted By 00blazer13

Welcome! I have the same yr. and model.

Welcome! I have the same yr. and model.
Forum: Steering, Suspension & Drivetrain
09-24-2011, 06:57 PM
Replies: 3
Views: 703
Posted By 00blazer13

Thanks! I decided to do the ball joints and outer...

Thanks! I decided to do the ball joints and outer tie rods also.
Forum: Tires and Wheels
09-24-2011, 06:54 PM
Replies: 10
Views: 8,321
Posted By 00blazer13

No, the wrangler radial tires. The cheap ones. I...

No, the wrangler radial tires. The cheap ones. I wont be doing any heavy off roading. Just want to get through snow and a little mud when I go hunting or fishing.
Forum: General Chat
09-22-2011, 07:49 PM
Replies: 5
Views: 4,592
Posted By 00blazer13

safety first!!! LOL

safety first!!! LOL
Forum: Tires and Wheels
09-22-2011, 07:25 PM
Replies: 10
Views: 8,321
Posted By 00blazer13

goodyear wrangler??

Thinking about putting Goodyear Wrangler 235/75/15 on a 2000 4x4 s10 blazer, stock everything. Any opinions or experience with this tire would be helpful.
Forum: Steering, Suspension & Drivetrain
09-22-2011, 06:48 PM
Replies: 3
Views: 703
Posted By 00blazer13

fixing up

Replacing tie rod ends and front axle seal this weekend.
Forum: New Member Area
09-16-2011, 11:53 PM
Replies: 8
Views: 547
Posted By 00blazer13

Mine has 145,000 on it. It was very neglected by...

Mine has 145,000 on it. It was very neglected by the previous owner. I am working out all the bugs in it though. It has been a learning experience for me. Luckily I am mechanically inclined.
Forum: New Member Area
09-15-2011, 07:14 PM
Replies: 8
Views: 547
Posted By 00blazer13

This forum is great. i have had a lot of problems...

This forum is great. i have had a lot of problems solved without posting them. I have not seen very many people from oklahoma
Forum: New Member Area
09-12-2011, 06:46 PM
Replies: 8
Views: 547
Posted By 00blazer13

Thanks! This forum has been very helpful in my...

Thanks! This forum has been very helpful in my quest to keep my Blazer alive.
Forum: 2nd Generation S-series (1995-2005) Tech
09-07-2011, 10:33 PM
Replies: 9
Views: 1,146
Posted By 00blazer13

overheating

You can also check under the oil fill cap. If there is moisture in it you may have coolant leaking into the engine. Like the other guys said, more info would be helpful. Does the coolant fill the...
Forum: New Member Area
09-07-2011, 10:11 PM
Replies: 8
Views: 547
Posted By 00blazer13

I wish it was a fun thing for me! So far I have...

I wish it was a fun thing for me! So far I have been trying to keep it alive since I bought it.
Forum: New Member Area
09-07-2011, 07:35 PM
Replies: 8
Views: 547
Posted By 00blazer13

newbie in oklahoma

working on 2000 s 10 blazer ls
Showing results 1 to 27 of 27


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands