Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: fishface
Showing results 1 to 18 of 18
Search took 0.01 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
11-09-2017, 05:14 PM
Replies: 29
Views: 10,712
Posted By fishface

Ok, finally got this fixed, it was the shift...

Ok, finally got this fixed, it was the shift cable, once it was removed you can see where it has worn and failed, the outer sheath was worn away and the inner sheath and cable and creased up, so got...
Forum: 2nd Generation S-series (1995-2005) Tech
10-18-2017, 11:21 AM
Replies: 29
Views: 10,712
Posted By fishface

Ok, I think I've got this. With the new...

Ok, I think I've got this.

With the new neutral safety switch installed, what I have now discovered is this.

I move the shifter to the park position, I then went under the car and gave the...
Forum: 2nd Generation S-series (1995-2005) Tech
10-15-2017, 04:37 PM
Replies: 29
Views: 10,712
Posted By fishface

I'll check that, what I have found is if I jumper...

I'll check that, what I have found is if I jumper 12v to the where the switched 12v (yellow wire) goes into the starter relay the car starts and runs fine.

So the yellow wire that goes into the...
Forum: 2nd Generation S-series (1995-2005) Tech
10-15-2017, 01:05 PM
Replies: 29
Views: 10,712
Posted By fishface

After digging around I found that the 12v feed to...

After digging around I found that the 12v feed to the ignition switched has been spliced together in the past, and was not good, re-made it and soldered it - it has fixed the 'no 12v' at the ignition...
Forum: 2nd Generation S-series (1995-2005) Tech
10-15-2017, 10:07 AM
Replies: 29
Views: 10,712
Posted By fishface

Fusible link on the load side. Yes, that is...

Fusible link on the load side.

Yes, that is correct, which is confusing.

The red wire goes through the multi-pin block connector first, so by jumpering it I have by-passed it, of course there...
Forum: 2nd Generation S-series (1995-2005) Tech
10-14-2017, 10:30 AM
Replies: 29
Views: 10,712
Posted By fishface

Every terminal block post shown in the photo has...

Every terminal block post shown in the photo has 12v with reference to the negative on the battery.

Every fusible link has 12v with reference to the negative on the battery.

The large red wire...
Forum: 2nd Generation S-series (1995-2005) Tech
10-07-2017, 11:48 AM
Replies: 29
Views: 10,712
Posted By fishface

Thanks George, I really appreciate your patience...

Thanks George, I really appreciate your patience with me.

I have found out one more thing, the starter relay is shot, it had recently been replaced, it smelt wrong, slight burnt smell, I then...
Forum: 2nd Generation S-series (1995-2005) Tech
10-03-2017, 06:34 PM
Replies: 29
Views: 10,712
Posted By fishface

So to test the hot red wire on the battery side...

So to test the hot red wire on the battery side of the ignition switch I test from the red wire coming from the battery to one side of the crank fuse?

Just to clarity - the crank fuse is 10A...
Forum: 2nd Generation S-series (1995-2005) Tech
10-02-2017, 10:52 AM
Replies: 29
Views: 10,712
Posted By fishface

I think I measured the crank fuse incorrectly, I...

I think I measured the crank fuse incorrectly, I measured across it, i.e. one probe on one side of the fuse contact and the other probe on the other one - the fuse continuity reads good.

I will...
Forum: 2nd Generation S-series (1995-2005) Tech
10-01-2017, 05:19 PM
Replies: 29
Views: 10,712
Posted By fishface

Where is he 'crank' fuse located? Is it in the...

Where is he 'crank' fuse located? Is it in the fuse box?

Ok, I found it, 10A labelled 'crank'!

0v at run, goes to 12v when trying to start.
Forum: 2nd Generation S-series (1995-2005) Tech
10-01-2017, 02:51 PM
Replies: 29
Views: 10,712
Posted By fishface

I've gone ahead and replaced the neutral safety...

I've gone ahead and replaced the neutral safety switch, it looked in bad shape, covered in dirt, oil and rust, still have the same issue.

The relay has 4 wires, red, purple, yellow and grey.
...
Forum: 2nd Generation S-series (1995-2005) Tech
09-30-2017, 04:48 PM
Replies: 3
Views: 3,692
Posted By fishface

It came out in the end with a bit more force. I...

It came out in the end with a bit more force. I discovered that you do not need to fully remove the drive shaft to replace the neutral safety switch, once you remove the drive shaft clamps you can...
Forum: 2nd Generation S-series (1995-2005) Tech
09-28-2017, 06:53 PM
Replies: 3
Views: 3,692
Posted By fishface

My world is not perfect...unfortunately! I didn't...

My world is not perfect...unfortunately! I didn't want to get to aggressive with without checking first, so really appreciate your advice.
Forum: 2nd Generation S-series (1995-2005) Tech
09-24-2017, 03:09 PM
Replies: 3
Views: 3,692
Posted By fishface

Drive shaft removal

I'm replacing the neutral safety switch on 1997 4x4, I've got the switch all loosened up but need to remove the drive shaft to make room to get the switch assembly out. I've removed the 4 bolts and...
Forum: 2nd Generation S-series (1995-2005) Tech
09-13-2017, 02:50 PM
Replies: 29
Views: 10,712
Posted By fishface

I was wondering if it is the neutral safety...

I was wondering if it is the neutral safety switch?
Forum: 2nd Generation S-series (1995-2005) Tech
09-10-2017, 10:05 AM
Replies: 29
Views: 10,712
Posted By fishface

Ok, I pulled he starter relay and took a few...

Ok, I pulled he starter relay and took a few voltage readings.

Red wire - constant 12v, when turning key to run, constant 12v
Purple wire to solenoid - no voltage when turning key to run, I...
Forum: 2nd Generation S-series (1995-2005) Tech
09-09-2017, 12:05 PM
Replies: 29
Views: 10,712
Posted By fishface

97 Blazer No Crank No Start

97 Blazer 4wd, 211k, had it around 3 months, some rust on the chassis, body in ok shape, interior in good shape, has been driving and shifting great.

Step-son was pulling up the driveway and the...
Forum: New Member Area
09-09-2017, 11:37 AM
Replies: 1
Views: 210
Posted By fishface

Hello

HI there!

Hoping to get some trouble-shooting tips on here and maybe contribute back, but I'm a shade tree mechanic, so probably receiving more info than giving!

I'm a Brit who has been living...
Showing results 1 to 18 of 18


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands