Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Cyberlight
Showing results 1 to 19 of 19
Search took 0.01 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
12-01-2011, 07:26 AM
Replies: 33
Views: 15,716
Posted By Cyberlight

What I did was snake my dremel up and over the...

What I did was snake my dremel up and over the cat from the back side to where my cutout wheel would allow me to cut the stud flush with the nut, then split both in two, to where I was left with a...
Forum: Steering, Suspension & Drivetrain
06-18-2011, 09:53 AM
Replies: 1
Views: 1,007
Posted By Cyberlight

Forgot how the power steering lines go

I took out my steering gear and like an idiot, I forgot how the lines go in the steering gear. Can someone verify what order they go in, i.e. does the one that goes to the cooler go in the hole...
Forum: Article Submissions/Discussions
06-12-2011, 05:11 AM
Replies: 44
Views: 13,927
Posted By Cyberlight

Thanks Kyle, My abs sensor is on the dust...

Thanks Kyle, My abs sensor is on the dust shield, so I guess 180 it is.
Forum: Article Submissions/Discussions
06-11-2011, 08:24 AM
Replies: 44
Views: 13,927
Posted By Cyberlight

Anybody? Axle nut torque for a 97 4x4? Is it...

Anybody? Axle nut torque for a 97 4x4? Is it 103? 130? 174? 180? I've seen all but can someone confirm this for me? Thanks.
Forum: 2nd Generation S-series (1995-2005) Tech
06-03-2011, 01:36 PM
Replies: 1
Views: 905
Posted By Cyberlight

Question about front hubs/ knuckles/ steering gear

Ok, I'm in the process of a front end overhaul. Long story short, I am replacing ball joints, tie rods, idler, and pitman arms. Vehicle is a 1997 4dr 4x4 blazer with 202k miles.

Question 1: ...
Forum: Article Submissions/Discussions
06-01-2011, 09:00 PM
Replies: 44
Views: 13,927
Posted By Cyberlight

What are the torque specs for 97? Could I use...

What are the torque specs for 97? Could I use this list for my 97 4x4 4dr? Thanks.

https://blazerforum.com/forum/general-tech-help-7/torque-specs-4164/
Forum: General Chat
01-05-2011, 10:32 AM
Replies: 360
Views: 72,631
Posted By Cyberlight

My 1997 LT 4X4 was bought by my mom in 2000 with...

My 1997 LT 4X4 was bought by my mom in 2000 with ~34k miles. She owned it until 2008 with 177k miles when I took it off her hands (she was just going to junk it). While she owned it, the following...
Forum: 2nd Generation S-series (1995-2005) Tech
01-03-2011, 03:03 PM
Replies: 2
Views: 14,010
Posted By Cyberlight

Thanks. I just finished up the fuel spider MFI...

Thanks. I just finished up the fuel spider MFI conversion, and it runs great. While I was waiting for the unit to ship from amazon, I did a heater core swap, and that seems to be working as well. ...
Forum: 2nd Generation S-series (1995-2005) Tech
12-29-2010, 09:16 AM
Replies: 2
Views: 14,010
Posted By Cyberlight

Upper Intake torque specs

1997 Blazer. I am in the process of replacing my fuel spider, and was wondering if anyone could tell me what the torque specs are for the upper intake manifold, as well as the sequence. I searched...
Forum: 2nd Generation S-series (1995-2005) Tech
12-22-2010, 11:06 PM
Replies: 2
Views: 641
Posted By Cyberlight

Today I removed my leaking heater core, and...

Today I removed my leaking heater core, and discovered that both halves of the housing, as well as the heater core itself are installed with some form of gasket. It looks as if it was squirted in...
Forum: 2nd Generation S-series (1995-2005) Tech
12-06-2010, 12:52 PM
Replies: 2
Views: 1,131
Posted By Cyberlight

Coolant Flush

Ok, so I need to do a few things to my 97 Blazer LT 4x4 4dr.

Needs fuel spider/regulator, and a heater core. Some questions I have are:

Are there any writeups for the 96 or 97 heater cores? ...
Forum: Engine & Transmission
11-17-2010, 07:31 AM
Replies: 5
Views: 1,234
Posted By Cyberlight

Oh yeah, I guess I should have included that. I...

Oh yeah, I guess I should have included that. I have a 1997 Blazer 4WD with 199400 miles.
Forum: Engine & Transmission
11-16-2010, 10:23 AM
Replies: 5
Views: 1,234
Posted By Cyberlight

Well about last March, the coil went out on my...

Well about last March, the coil went out on my when I was driving, had it towed becasue I didn't know what was wrong, guy who fixed it said he replaced the coil and noticed the idle misfire, he tried...
Forum: Engine & Transmission
11-16-2010, 08:02 AM
Replies: 5
Views: 1,234
Posted By Cyberlight

Fuel spider conversion

Ok guys, I've spent a lot of time searching through the forums and found that several people have experienced the same problems I am having which are:

Hard starting,
Misfire at idle,...
Forum: Engine & Transmission
05-17-2010, 07:25 PM
Replies: 1
Views: 594
Posted By Cyberlight

Misfire at idle

I have a 1997 blazer 4dr 4x4, with 195k miles. I had the P0300 code, tried plugs and wires, to no avail. A little later, my coil pack blew out and I had to have it towed. The mechanic said he...
Forum: 2nd Generation S-series (1995-2005) Tech
11-08-2009, 06:23 AM
Replies: 23
Views: 78,764
Posted By Cyberlight

So if I understand everyone correctly, and...

So if I understand everyone correctly, and looking at the pictures posted, replacing the entire distributor seems to be the correct course of action? Is it an easy swap out? Is there room to just...
Forum: 2nd Generation S-series (1995-2005) Tech
10-11-2009, 09:16 AM
Replies: 33
Views: 15,716
Posted By Cyberlight

A lot of you probably already know this, but I...

A lot of you probably already know this, but I figured I'd share my experience in hopes it will help someone. I had this rattle problem with my 97. Thought it was a heat shield, but they were all...
Forum: 2nd Generation S-series (1995-2005) Tech
10-11-2009, 08:58 AM
Replies: 1
Views: 628
Posted By Cyberlight

4x4 disengaging problem

I have a 97 blazer with 190k miles, and here is my problem. Recently, I engaged the 4hi to get out of a muddy parking lot, and upon getting back to the road, I put it back to 2 hi, but I could tell...
Forum: 2nd Generation S-series (1995-2005) Tech
10-11-2009, 07:58 AM
Replies: 23
Views: 78,764
Posted By Cyberlight

Hello, I'm wondering if this could be my issue. ...

Hello, I'm wondering if this could be my issue. I have a 97 Blazer with 190k miles and have a problem with severe missing under light throttle from about 2 to 3k rpm, and while cruising at highway...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands