Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: upmaine
Showing results 1 to 21 of 21
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
08-26-2012, 01:57 PM
Replies: 2
Views: 1,962
Posted By upmaine

Replacing transmission on 99 blazer

How hard is it to replace an auto transmission on a 99 blazer with 4wd. I have a used transmission that I would like to put in my blazer but before I tackel this myself I kind of wanted to know what...
Forum: 2nd Generation S-series (1995-2005) Tech
07-14-2012, 12:48 PM
Replies: 1
Views: 5,144
Posted By upmaine

99 blazer transmission no reverse and drive not changing gears that good.

We went to use the Blazer this morning and when I went to put it into reverse it did nothing. No grinding nothing at all. when I put it into reverse it makes no noise at all it's like being in...
Forum: 2nd Generation S-series (1995-2005) Tech
07-08-2012, 11:08 PM
Replies: 2
Views: 7,039
Posted By upmaine

Passenger side of 99 blazer sits alot lower then drivers side ?

I have 99 blazer with 4wd and over the past couple years I have noticed the passenger side starting to drop lower than the drivers side. when you stand in the back you can see that the passeneger...
Forum: 2nd Generation S-series (1995-2005) Tech
06-26-2012, 01:54 AM
Replies: 1
Views: 4,290
Posted By upmaine

Clunking noise coming from rear of Blazer

I have a 99 4wd blazer and when I go to go forward or reverse I'm hearing a clunk sound from the rear of blazer. I'm also hearing it as I slwo down. when I get around 25/30 mph and I think it's when...
Forum: 2nd Generation S-series (1995-2005) Tech
09-05-2010, 05:11 AM
Replies: 8
Views: 26,010
Posted By upmaine

How did you make out getting the bolt out. Also I...

How did you make out getting the bolt out. Also I don't know why know one told you this but If you hear the moaning noise when turning left it's the right side hub bearing that's bad and if you hear...
Forum: 2nd Generation S-series (1995-2005) Tech
08-27-2010, 11:28 PM
Replies: 2
Views: 10,234
Posted By upmaine

warning brake light stays on even after bleeding brakes

I have a 99 blazer 4wd and last weekend while pulling our camper I had to stop quickly and got a leak on the brake line in a rusted area right under drivers seat that goes to rear brakes. I was able...
Forum: 2nd Generation S-series (1995-2005) Tech
08-25-2010, 06:39 PM
Replies: 5
Views: 4,335
Posted By upmaine

After I get the bolt out is there anyway to get a...

After I get the bolt out is there anyway to get a clip back in there. There is only about a 1 inch gap between the frame and the body. Or is it just easier to use a nut an bolt. I guess the easiest...
Forum: 2nd Generation S-series (1995-2005) Tech
08-25-2010, 05:12 PM
Replies: 2
Views: 810
Posted By upmaine

Help with whole in brake line out in northern maine woods.

We are on vacation right now in northern maine and we blew a hole in the brake line going to the back brakes today. The hole is right under the drivers seat on the frame. The brake line looks pretty...
Forum: 2nd Generation S-series (1995-2005) Tech
08-25-2010, 04:54 PM
Replies: 5
Views: 4,335
Posted By upmaine

Just got back from vacation. Now I can continue...

Just got back from vacation. Now I can continue working on the rear shocks. I looked on top of the frame were the bolt comes thru to see if I could see a clip turning and the only thing I couls see...
Forum: 2nd Generation S-series (1995-2005) Tech
08-15-2010, 01:22 PM
Replies: 5
Views: 4,335
Posted By upmaine

Help replacing rear shocks on my 99 blazer

I went to replace the rear shocks on my 99 blazer and everything was going good until one of the top bolts will not come out. It just spins and spins. Any ideas on how to remove that bolt.
Forum: 2nd Generation S-series (1995-2005) Tech
07-21-2010, 10:41 AM
Replies: 4
Views: 9,496
Posted By upmaine

fuel pressure drops after engine is shut off

I have a 99 blazer with a 4.3 and after the blazer sits for a little while it takes a 3 to 4 turns of the key to make it start so I checked the fuel pressure and it's ok but as soon as I shut the...
Forum: 2nd Generation S-series (1995-2005) Tech
07-18-2010, 11:01 PM
Replies: 0
Views: 2,328
Posted By upmaine

Replacing fuel pressure regulator

I have a 1999 blazer with a Vortec 4.3 engine and I'm trying to find the Fuel pressure regulator. the regulator is not holding pressure anymore and I need to replace it and I tried locating it today...
Forum: Engine & Transmission
04-15-2010, 05:42 PM
Replies: 8
Views: 4,890
Posted By upmaine

swartlkk I did unplug the MAF sensor and when I...

swartlkk
I did unplug the MAF sensor and when I go to remove the air duct from on top of the throttle body the engine dies. when I unplug the MAF sensor the engine keeps running just fine. but just...
Forum: Steering, Suspension & Drivetrain
04-06-2010, 10:05 AM
Replies: 1
Views: 2,264
Posted By upmaine

rancho rs 500 versus reflex monotube

I replaced the front shocks on my 99 blazer 3 months ago with some monroe sensatrac's and yesterday while I was changing the oil I noticed that both shocks were leaking oil pretty bad. they are under...
Forum: Engine & Transmission
04-06-2010, 02:40 AM
Replies: 8
Views: 4,890
Posted By upmaine

I thought that also so I unplugged the MAF sensor...

I thought that also so I unplugged the MAF sensor to see what would happen and nothing happened. The engine kept running fine.
i could not understand why the engine would die when i went to pull...
Forum: Engine & Transmission
04-04-2010, 11:24 PM
Replies: 8
Views: 4,890
Posted By upmaine

engine dies after removing throttle body duct

I went to clean the throttle body on my 99 4wd 4.3 vortex engine and while it was running I went to take the air intake duct cover off the throttle body and as soon as I would start to pull it off...
Forum: Engine & Transmission
03-09-2010, 02:42 AM
Replies: 9
Views: 5,827
Posted By upmaine

I had a complete tune up done 4 months ago and...

I had a complete tune up done 4 months ago and the blzer doesn't have to sit for a long time for it to do this. I can shut it down and start it right back up and it will crank for several seconds...
Forum: Engine & Transmission
03-08-2010, 07:30 PM
Replies: 9
Views: 5,827
Posted By upmaine

Blazer taking longer to start up

Prior to this past weekend my 99 6cyl 4wd blazer always started right up on the first crank. But since this past weekend it takes alot longer to start now. It has to crank over several times before...
Forum: Steering, Suspension & Drivetrain
03-03-2010, 06:58 PM
Replies: 17
Views: 85,579
Posted By upmaine

I just went and compared prices on the same kind...

I just went and compared prices on the same kind of shocks at NAPA and shockwarehouse and they were cheaper at NAPA.
Forum: Steering, Suspension & Drivetrain
02-27-2010, 05:31 PM
Replies: 15
Views: 23,001
Posted By upmaine

I have a 99 4wd blazer and I had the same problem...

I have a 99 4wd blazer and I had the same problem with the front end shaking at speeds between 65 and 75 and I had my mechanic go thru the whole front end and he could not find anything wrong so all...
Forum: Engine & Internal
02-26-2010, 02:21 AM
Replies: 14
Views: 12,848
Posted By upmaine

RPMS fluctuating

I just had the same problem with my 99 blazer and it was the crankshaft sensor that was bad. I replaced it and now everything is fine.
Showing results 1 to 21 of 21


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands