Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: blazerhelp01
Showing results 1 to 36 of 36
Search took 0.01 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
06-13-2015, 04:33 PM
Replies: 7
Views: 3,396
Posted By blazerhelp01

Replaced oil lines, filter, running 10-30 with...

Replaced oil lines, filter, running 10-30 with Lucas, also replaced oil by bypass valve and oil sensor. Any ideas on that. Don't think bearings or can are bad
Forum: 2nd Generation S-series (1995-2005) Tech
06-13-2015, 04:30 PM
Replies: 7
Views: 3,396
Posted By blazerhelp01

When replacing the new sensor the engine don't...

When replacing the new sensor the engine don't run just cranks... Tried shims no shims finally put old one back in starts right up. Won't run at all to do crank relearn.. Oil pressure still drops at...
Forum: 2nd Generation S-series (1995-2005) Tech
06-13-2015, 06:08 AM
Replies: 7
Views: 3,396
Posted By blazerhelp01

yes misfire seems worse at normal temp. and oil...

yes misfire seems worse at normal temp. and oil does drop at normal temp when idling about 10 lb. moves up to 30 when giving gas. also the tach seems to jump as it misfire pretty good. motor doesnt...
Forum: 2nd Generation S-series (1995-2005) Tech
06-13-2015, 06:01 AM
Replies: 7
Views: 3,396
Posted By blazerhelp01

the oil pressure does drop when it warms up and...

the oil pressure does drop when it warms up and is at idle. but goes right back up when i give it gas. there is no knocking or ticking that i can here and when removed valve covers seemed to get...
Forum: 2nd Generation S-series (1995-2005) Tech
06-08-2015, 02:48 AM
Replies: 7
Views: 3,396
Posted By blazerhelp01

Angry OBD2 Readings need help with freeze frame data

2001 chevy blazer LT 4x4
p0304 cylinder 4 misfire
p0335 crankshaft position sensor

p0304 Freeze Frame Data

Fuel sys 1 CL
Fuel sys 2 CL
Calc Load (%) 4.3
ECT (`F) ...
Forum: 2nd Generation S-series (1995-2005) Tech
04-03-2015, 09:36 PM
Replies: 54
Views: 118,486
Posted By blazerhelp01

Thank you so much. I guess 16mm flare wrench is a...

Thank you so much. I guess 16mm flare wrench is a specialty wrench can't find one. Guess I'll try sears. Thanks again.
Forum: 2nd Generation S-series (1995-2005) Tech
04-03-2015, 08:47 PM
Replies: 54
Views: 118,486
Posted By blazerhelp01

what size is the flare wrench to remove the fuel...

what size is the flare wrench to remove the fuel filter Captain Hook??
Forum: Engine & Transmission
03-30-2015, 09:31 PM
Replies: 15
Views: 1,869
Posted By blazerhelp01

not sure how to tell if its in open or closed...

not sure how to tell if its in open or closed loop. it always says freeze frame. ill delete the codes every time to make sure they are present codes. it says closed loop.? ill drive it for like 20...
Forum: Engine & Transmission
03-30-2015, 06:43 PM
Replies: 15
Views: 1,869
Posted By blazerhelp01

closed loop

heres new results with closed loop.
MIL DTC P0304 Cylinder 4 Misfire Detected View Stored Codes P0304 Cylinder 4 Misfire Detected View ...
Forum: Engine & Transmission
03-29-2015, 11:58 PM
Replies: 15
Views: 1,869
Posted By blazerhelp01

Thank you Captain Hook. will try this again......

Thank you Captain Hook. will try this again... Thanks again for all the help.
Forum: Engine & Transmission
03-29-2015, 05:44 PM
Replies: 15
Views: 1,869
Posted By blazerhelp01

Smile so sorry... Thanks for all your help....

a Vacum line was off. So I re tested.. so sorry.
Transmission Diagnostic Trouble Code Information MIL DTC P0304 Cylinder 4 Misfire Detected View Stored...
Forum: Engine & Transmission
03-29-2015, 02:53 PM
Replies: 15
Views: 1,869
Posted By blazerhelp01

Captain Hook, You are amazing. Thank you for...

Captain Hook, You are amazing. Thank you for helping me out. I sorry I know you have to be sick of me by now. I have no idea what im doing, but trying to learn. Thank you for all the help. I did like...
Forum: 2nd Generation S-series (1995-2005) Tech
03-28-2015, 02:04 AM
Replies: 19
Views: 3,687
Posted By blazerhelp01

Angry Bad Distributor ??? dtc p0300 dtc p0304

replaced cap and rotor. noticed when i canged the rotor it seemed little loose. re placed with ac delco. thightened rotor down but still seams little loose. has some play. but no up and down play....
Forum: Engine & Transmission
03-28-2015, 12:25 AM
Replies: 15
Views: 1,869
Posted By blazerhelp01

thats the info I just got off my annova 3100g abs...

thats the info I just got off my annova 3100g abs canOBD2 Diagnostic tool.
MIL DTC P0304

STORED CODES P0304, P0334

PENDING CODES P0304
Not sure what to do next? please help
Forum: Engine & Transmission
03-27-2015, 11:35 PM
Replies: 15
Views: 1,869
Posted By blazerhelp01

Freeze Frame Information ...

Freeze Frame Information
Parameter Description
Results

...
Forum: Engine & Transmission
03-27-2015, 11:24 PM
Replies: 15
Views: 1,869
Posted By blazerhelp01

Freeze Frame Information ...

Freeze Frame Information
Parameter Description
Results

...
Forum: Engine & Transmission
03-21-2015, 10:37 PM
Replies: 15
Views: 1,869
Posted By blazerhelp01

also engine seems to be getting plenty of oil and...

also engine seems to be getting plenty of oil and not making any noise. running out of money just chasing probs
Forum: Engine & Transmission
03-21-2015, 10:34 PM
Replies: 15
Views: 1,869
Posted By blazerhelp01

Angry random misfire wtf??? please someone help

2001 4x4 LT random misfire, can barley tell at idle. was driving great even with check engine light on.
Now SES light flashes while driving. also noticed the tach jumps a little bit while driving....
Forum: Engine & Transmission
03-09-2015, 05:58 PM
Replies: 0
Views: 1,386
Posted By blazerhelp01

Unhappy oil filter adapter removal help...

replacing the oil bypass valve. couldn't get to the bolt to take the oil lines off the oil filter adapter. 2001 blazer 4x4. took bolts out of adapter hoping it would drop down enough to remove the...
Forum: 2nd Generation S-series (1995-2005) Tech
03-09-2015, 05:34 PM
Replies: 28
Views: 18,731
Posted By blazerhelp01

replacing my bypass valve now. couldn't get to...

replacing my bypass valve now. couldn't get to the bolt to loosen the lines. figured if i took bolts out of the adapter it would drop down enough to get the lines loose. no luck. do you have to...
Forum: 2nd Generation S-series (1995-2005) Tech
03-06-2015, 09:49 PM
Replies: 11
Views: 1,630
Posted By blazerhelp01

ok thank you I will start there... thanks so much.

ok thank you I will start there... thanks so much.
Forum: 2nd Generation S-series (1995-2005) Tech
03-06-2015, 09:15 PM
Replies: 11
Views: 1,630
Posted By blazerhelp01

mechanic did say the compression was good on...

mechanic did say the compression was good on motor. and has great throttle responce and you cant even really tell if there is a miss. One thing i did notice is the tach gauge when you hit about 2000...
Forum: 2nd Generation S-series (1995-2005) Tech
03-06-2015, 09:08 PM
Replies: 11
Views: 1,630
Posted By blazerhelp01

when I bought the blazer it had service engine...

when I bought the blazer it had service engine soon light on. drove and ran great. checked it at o' riellys auto part and scanner said po300 random miss fire and po410 secondary air system. noticed...
Forum: 2nd Generation S-series (1995-2005) Tech
03-06-2015, 08:30 PM
Replies: 11
Views: 1,630
Posted By blazerhelp01

Thank you so much. love my new blazer but have...

Thank you so much. love my new blazer but have had probs with it since I bought it like a month ago. dtc po300 showing. but seems to run good. ses light started to flash on freeway. just fixed crank...
Forum: 2nd Generation S-series (1995-2005) Tech
03-06-2015, 06:37 PM
Replies: 11
Views: 1,630
Posted By blazerhelp01

why does it drop so low after warm up?? doesn't...

why does it drop so low after warm up?? doesn't seem right?? also just changed oil and filter. K&N filter and 5w-30 oil witch is what recommended in manual
Forum: 2nd Generation S-series (1995-2005) Tech
03-06-2015, 06:34 PM
Replies: 11
Views: 1,630
Posted By blazerhelp01

it seems to run normal when first started at cool...

it seems to run normal when first started at cool temp.
Forum: 2nd Generation S-series (1995-2005) Tech
03-06-2015, 06:28 PM
Replies: 11
Views: 1,630
Posted By blazerhelp01

it seems pretty low?? My buddy's blazer idles...

it seems pretty low?? My buddy's blazer idles about 20-25psi and when driving is about 40-45 psi. and has 10,000 more miles on it. also when driving and come to a stop it looks like it wants to drop...
Forum: 2nd Generation S-series (1995-2005) Tech
03-06-2015, 06:13 PM
Replies: 11
Views: 1,630
Posted By blazerhelp01

2001 oil check valve??? Special tool??

I have a 2001 Blazer LT. when its cold the oil gauge at idle is about 40 psi. while driving its about 45-50 psi. when engine warms up to normal operating temp the oil gauge drops to about 10 psi at...
Forum: Engine & Transmission
03-03-2015, 06:19 PM
Replies: 10
Views: 3,524
Posted By blazerhelp01

Thank you so much for all the great info. Think...

Thank you so much for all the great info. Think Ill replace with ac delco and find a shop to relearn the code.
Forum: Engine & Transmission
03-03-2015, 12:03 AM
Replies: 10
Views: 3,524
Posted By blazerhelp01

Talking sorry little slow here. just makin sure. hope the...

sorry little slow here. just makin sure. hope the old sensor gets me to where i need to go, to a scanner to relearn the code?? wonce I make it there, were ever that is lol. Put the new sensor in and...
Forum: Engine & Transmission
03-02-2015, 11:24 PM
Replies: 10
Views: 3,524
Posted By blazerhelp01

Thank you for the info. I guess im stuck in my...

Thank you for the info. I guess im stuck in my drive way with it then. i already removed the sensor. new one wont fire the blazer up. yea he said dtc p0300 I believe. I know there was a dtc he talked...
Forum: Engine & Transmission
03-02-2015, 10:02 PM
Replies: 10
Views: 3,524
Posted By blazerhelp01

Angry Need Help 2001 crankshaft sensor!!!! Please

Took my blazer to my moms mec. told me the p0300 code from my engine was prob the crankshaft sensor. i already changed plugs and wires. sooo I bought a new one went home to change right away. SURE...
Forum: 2nd Generation S-series (1995-2005) Tech
02-19-2015, 12:35 PM
Replies: 4
Views: 3,584
Posted By blazerhelp01

Gonna go thicker next oil change not sure what's...

Gonna go thicker next oil change not sure what's the best weight. I live in desert so it gets hot here.
Forum: 2nd Generation S-series (1995-2005) Tech
02-19-2015, 12:32 PM
Replies: 4
Views: 3,584
Posted By blazerhelp01

5w-30 with Lucas oil stabilizer

5w-30 with Lucas oil stabilizer
Forum: 2nd Generation S-series (1995-2005) Tech
02-19-2015, 12:27 AM
Replies: 4
Views: 3,584
Posted By blazerhelp01

really low oil pressure worried..

just bought a 2001 chevy blazer had for few days now and noticed the oil gauge was pretty low. about 20-25 when on the gas. when at a stop or just idle is like 5-10. runs good now oil light on seems...
Forum: 2nd Generation S-series (1995-2005) Tech
02-18-2015, 11:46 PM
Replies: 1
Views: 648
Posted By blazerhelp01

Exclamation 2001 blazer need help please

just bought used 2001 blazer 4x4 157000 miles, check engine light was is on. they told me it was a misfire code. said it was prob gonna be plugs or wires. truck runs great until at an idle then seems...
Showing results 1 to 36 of 36


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands