Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Hate this blazer
Showing results 1 to 21 of 21
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
11-10-2017, 07:37 AM
Replies: 12
Views: 1,044
Posted By Hate this blazer

Better but still not right

I have the brakes on my 98 Blazer working a lot better than they did before. Now the pedal depresses about an inch to an inch and a half before the brakes engage instead of to the floor. The truck is...
Forum: 2nd Generation S-series (1995-2005) Tech
11-08-2017, 01:28 AM
Replies: 11
Views: 1,180
Posted By Hate this blazer

Replaced wheel bearing

After replacing the wheel bearing the humming went away but and thewomp womp womp sound is still present, it does increase/ decrease with speed and goes it at any speed. I noticed the tire on that...
Forum: 2nd Generation S-series (1995-2005) Tech
11-08-2017, 01:12 AM
Replies: 11
Views: 1,180
Posted By Hate this blazer

Looks loose to me

I felt like both ball joints and inner/ outer tie rod ends on both sides looked like they needed replacing but I found very little movement out of any of them. A friend of mine had 4 tie rod ends...
Forum: Steering, Suspension & Drivetrain
11-06-2017, 02:10 PM
Replies: 4
Views: 504
Posted By Hate this blazer

Thanks

thanks for the info, I learned a little something about front ends today. It actually ended up being a wheel bearing and the thumping sound caused by a flat spot in the bearing with explains the...
Forum: 2nd Generation S-series (1995-2005) Tech
11-06-2017, 04:14 AM
Replies: 11
Views: 1,180
Posted By Hate this blazer

thanks for the info, I'll check on the wheel...

thanks for the info, I'll check on the wheel bearing, I should be able to turn it by hand without the wheel, caliper, etc. Off or do I need something to turn it w
With?
Forum: 2nd Generation S-series (1995-2005) Tech
11-06-2017, 02:21 AM
Replies: 11
Views: 1,180
Posted By Hate this blazer

update, I know those are the sway bar links and...

update, I know those are the sway bar links and probably not causing my problem. As stated has a womp womp womp sound and pulls slightly to the left. Not as hard as if the caliper were sticking, but...
Forum: 2nd Generation S-series (1995-2005) Tech
11-06-2017, 02:18 AM
Replies: 11
Views: 1,180
Posted By Hate this blazer

Need advice badly

I have a 98 blazer lt, I started having a womp womp womp sound coming from the left front noticeably. I thought it was probably a belt in tire or tie rod end or wheel bearing at worst. But I just...
Forum: Steering, Suspension & Drivetrain
11-05-2017, 11:47 PM
Replies: 4
Views: 504
Posted By Hate this blazer

Thank you

thanks for the quick reply Rex, also my oldest son's name, it seems I have another problem then, if you wouldn't mind hearing it. As stated it makes a womp womp womp sound and increases as you speed...
Forum: Steering, Suspension & Drivetrain
11-05-2017, 11:01 PM
Replies: 4
Views: 504
Posted By Hate this blazer

Please need help!!

I have a 98 blazer lt, I started having a womp womp womp sound coming from the left front noticeably. I thought it was probably a belt in tire or tie rod end or wheel bearing at worst. But I just...
Forum: 2nd Generation S-series (1995-2005) Tech
11-04-2017, 05:56 AM
Replies: 4
Views: 700
Posted By Hate this blazer

Similar problem

WAS MEANT FOR DEBAGO 77 SORRY. My 4.3 was running fine and would rev in park/ neutral but became rough when load was applied- drive or reverse. I replaced plugs, cap and a couple other...
Forum: 2nd Generation S-series (1995-2005) Tech
11-04-2017, 05:40 AM
Replies: 10
Views: 32,818
Posted By Hate this blazer

Stupid design

I ran across bad regulators a few months ago, I had to replace my fuel pump so I figured regulator and filter would be good idea as well, except I purchased 2 faulty regs. In a row. And whoever...
Forum: 2nd Generation S-series (1995-2005) Tech
11-04-2017, 05:17 AM
Replies: 7
Views: 463
Posted By Hate this blazer

Sure is

I helped a friend replace a multi function on his 95 and not only was it frustrating it was expensive. What happened to simple mechanical parts and pieces that seemed to last twice as long and cost...
Forum: 2nd Generation S-series (1995-2005) Tech
11-02-2017, 11:24 PM
Replies: 7
Views: 463
Posted By Hate this blazer

Problem solved thanks everyone

lannyl81 good call on this one as I was checking wiring at the column I found that a wire from the connector you spoke of had a couple wires almost pulled out of the connector. I think they were...
Forum: 2nd Generation S-series (1995-2005) Tech
11-02-2017, 11:09 PM
Replies: 12
Views: 1,044
Posted By Hate this blazer

Yes please

hi Christine my blazer is a 98 which should be the same thing, and it's an LT if that makes any difference. I appreciate that you will do that, says lots about your character, I like it. Thank you
Forum: 2nd Generation S-series (1995-2005) Tech
11-01-2017, 08:05 PM
Replies: 12
Views: 1,044
Posted By Hate this blazer

I wasn't clear

sorry, I'm aware of bleeding farthest to nearest I meant to ask if there was a certain way to bleed proportioning valve? Not sure if it's the same process or a certain sequence or procedure to it....
Forum: 2nd Generation S-series (1995-2005) Tech
11-01-2017, 10:08 AM
Replies: 12
Views: 1,044
Posted By Hate this blazer

ive heard this before and I'm going to try it,...

ive heard this before and I'm going to try it, curious though why lift the rear end? Seems like it would deter fluid from calipers. After that you had good brakes though. Definitely worth doing...
Forum: 2nd Generation S-series (1995-2005) Tech
11-01-2017, 10:03 AM
Replies: 7
Views: 463
Posted By Hate this blazer

Was afraid of that, I may have done something...

Was afraid of that, I may have done something putting the booster in as well, as you know it's pretty tight under the dash especially with bolts behind steering column. thanks for replying.​​​​​​
Forum: 2nd Generation S-series (1995-2005) Tech
11-01-2017, 04:34 AM
Replies: 12
Views: 1,044
Posted By Hate this blazer

Christine

hey it seems to be softer as the engine is running but when it's not the booster isn't working so I believe the pedal is harder without just because of the building up of pressure with no booster...
Forum: 2nd Generation S-series (1995-2005) Tech
10-31-2017, 06:47 PM
Replies: 12
Views: 1,044
Posted By Hate this blazer

Scan tool

thanks Raybz, I have access to a high end scanner if I need to, but is there a particular procedure to bleeding the ABS? Also I read you can trick the valves for the rear line into opening so you can...
Forum: 2nd Generation S-series (1995-2005) Tech
10-31-2017, 06:36 PM
Replies: 7
Views: 463
Posted By Hate this blazer

Right turn Clyde

I have a 1998 blazer LT, on top of the brake problem I posted about, I have a turn signal issue. When I switch on right turn it blinks as if a bulb is blown, but both front bulbs and the rear were...
Forum: 2nd Generation S-series (1995-2005) Tech
10-30-2017, 08:12 PM
Replies: 12
Views: 1,044
Posted By Hate this blazer

Suggestions

Recently installed a new brake booster and pedal is soft and goes near floor. The MC remained full of fluid during entire process, and I have bled 3 times. 1st question: should the engine be running...
Showing results 1 to 21 of 21


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands