Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Terje
Showing results 1 to 9 of 9
Search took 0.00 seconds.
Forum: Lighting & Electrical
03-03-2017, 08:53 AM
Replies: 0
Views: 433
Posted By Terje

All lighting on dashboard gone, and unable to engage 4wd., 95 blazer

hi folks!
soo, I'am currently having a bit of a annoying problem with my blazer s10 95.
All the lighting around the ac control, inside the speedometer, and all over the dashboard are not working....
Forum: Engine & Transmission
09-16-2015, 01:30 PM
Replies: 2
Views: 723
Posted By Terje

Problem solved :)

Thank for the tip.
The problem was pretty obvious when I looked inside the EGR valve. A small rock or probably a very hard lump of soot was preventing the valve from closing.
Removed the rock and...
Forum: Engine & Transmission
09-14-2015, 02:37 PM
Replies: 2
Views: 723
Posted By Terje

Very rough uneven idle, hard to start, stops at traffic lights.What could cause this?

Hi,

I have a 1995 blazer LT with the 4,3l vortec engine.
Suddenly when I was out driving the other day the car starts acting real funny when stopping at traffic lights and such.
It start...
Forum: Engine & Transmission
03-13-2014, 07:30 PM
Replies: 4
Views: 2,335
Posted By Terje

That's fore sure :D the cheapest trans oil at my...

That's fore sure :D the cheapest trans oil at my local workshop costs around 20USD a quart. so 180USD fore 25quart's is a good deal fore me you can say :)

My blazer is the 4 door LT type.
I know...
Forum: Engine & Transmission
03-03-2014, 06:42 AM
Replies: 4
Views: 2,335
Posted By Terje

Transmission flush

Hey


I have a 1995 S10 with 200 000 km.. And the transmission has been a little of its game lately, it waits waay to long to shift gear and the shifting isn't that smooth :)

So to try fixing...
Forum: 2nd Generation S-series (1995-2005) Tech
02-12-2014, 04:46 AM
Replies: 10
Views: 32,818
Posted By Terje

It turned out to be the FPR that not was opening...

It turned out to be the FPR that not was opening at all..
I tried the hammer on it gently, and some other things, but it refused to open..

So i put in the old one again..

Soo that was a lot...
Forum: 2nd Generation S-series (1995-2005) Tech
01-31-2014, 04:43 PM
Replies: 10
Views: 32,818
Posted By Terje

Okay, no i haven't tested the gauge on...

Okay,
no i haven't tested the gauge on anything else. so i will do that.

But is it even possible to connect the FPR in a way that it will not work?
If it's not leaking external or internal, and...
Forum: 2nd Generation S-series (1995-2005) Tech
01-30-2014, 10:53 PM
Replies: 10
Views: 32,818
Posted By Terje

Very high fuel pressure after replacing fuel pump and regulator

Hey guys!

I have recently bought a 1995 blazer with the 4,3 vortec CPI engine.
And believe it or not,, I have run into some problems with the beloved fuel system.

Now I have finally got it...
Forum: 2nd Generation S-series (1995-2005) Tech
12-19-2013, 07:00 PM
Replies: 9
Views: 2,559
Posted By Terje

Hey Lars I think your blazer has gone...

Hey Lars

I think your blazer has gone totally åt skogen..

there is to much lurium in the motor..

buy a new and better one, and never scruw it up.


regards,
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands