Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: noxendine4u
Showing results 1 to 9 of 9
Search took 0.00 seconds.
04-29-2012, 10:00 PM
Replies: 3
Views: 1,714
Posted By noxendine4u

Red face vents don't work

when i run my air it comes to defrost and/or floor no vents..I followed the line to the engine compartment and chased it to a round canister, then down to the tranny. By the way my 96 blazer LS...
04-29-2012, 09:44 PM
Replies: 0
Views: 3,122
Posted By noxendine4u

Talking 4L60E Vacuum lines

Hey, it takes off slow. but once you get going it runs good. Vacuum? And since i just bought it it has a vibration @30- 65+. Could it be a tranny mount? tried u-joints,fluid ect..:icon_flamethrow:
04-29-2012, 09:39 PM
Replies: 13
Views: 776
Posted By noxendine4u

Thanks to all!!

Thanks to all!!
04-25-2012, 09:32 PM
Replies: 13
Views: 776
Posted By noxendine4u

:icon_doh:KPA

:icon_doh:KPA
04-25-2012, 09:30 PM
Replies: 13
Views: 776
Posted By noxendine4u

Hey

I'm from Blount co. Maryville. near knoxville airport. you?
04-22-2012, 07:29 PM
Replies: 13
Views: 776
Posted By noxendine4u

Green horn!! E. Tennessee.

Hey guys, I been reading alot of good advice on here thought I would join. I bought a 96' Blazer LT for $800. The guy said it needed a tranny but it was just out of fluid. (blessed) But they replaced...
04-22-2012, 06:03 PM
Replies: 4
Views: 3,404
Posted By noxendine4u

rear transfer case

96 blazer LT. iI look at the drive shaft and noticed that the tag on the rear transfer case says 272 ratio. Could that cause the whining noise that i hear?
04-22-2012, 07:28 AM
Replies: 4
Views: 3,404
Posted By noxendine4u

Thanks for the reply. I'm new at this. It whines...

Thanks for the reply. I'm new at this. It whines the faster you go. It seems to be vibrating when going slow. Like the gears are meshing really hard, (ring and pinion) i don't know. The vibration...
04-21-2012, 08:52 PM
Replies: 4
Views: 3,404
Posted By noxendine4u

rearend noise

96 blazer S10. Have alot of whinning out of the rearend. looks like it has a new tranny in it. all the u-jionts and d.shafts are good any suggestions? Could the gear ratio be off or what,...
Showing results 1 to 9 of 9


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands