Blazer Forum - Chevy Blazer Forums - Search Results

Community
Search
Search: Posts Made By: tululilopo
Showing results 1 to 24 of 24
Search took 0.00 seconds.
09-01-2010, 03:38 AM
Replies: 1
Views: 822
Posted By tululilopo

Finally fixed my Blazer!

I've had problems with the car idling sometimes, it would shake really bad, and eventually die. Turns out, only one of the two fuel injectors was spraying fuel. So, after thinking it was a problem...
07-06-2010, 02:57 PM
Replies: 143
Views: 69,483
Posted By tululilopo

I'll look into the high flow mufflers, but the...

I'll look into the high flow mufflers, but the gutted cat has opened up a ton of power. Even with the restrictive stock muffler, I'm averaging 1-2 more MPG. Most of the modifications I do are for...
07-05-2010, 04:07 PM
Replies: 7
Views: 761
Posted By tululilopo

SFA= Solid Front Axle, IFS= Independent Front...

SFA= Solid Front Axle, IFS= Independent Front Suspension. The main advantage of IFS is handling, and in some cases, ride quality. Each wheel on a vehicle with IFS stays perpendicular to the ground,...
07-05-2010, 02:04 AM
Replies: 143
Views: 69,483
Posted By tululilopo

I was going through all of my subscribed threads,...

I was going through all of my subscribed threads, and found this one again. Haha. No, my thrush rusted out, but I didn't notice it until I crawled up underneath the car to run a pipe through my...
07-03-2010, 09:35 AM
Replies: 5
Views: 6,146
Posted By tululilopo

Also, since it's a 4WD, you have torsion bars...

Also, since it's a 4WD, you have torsion bars running from the lower control arm, to about halfway down the frame.
07-02-2010, 01:09 PM
Replies: 3
Views: 1,170
Posted By tululilopo

If it's a 4WD, then the the front has torsion...

If it's a 4WD, then the the front has torsion bars. They are your springs. You can go on JCWhitney or other websites and get "torsion keys" that will lift the front end up and inch or two. But your...
07-02-2010, 12:04 PM
Replies: 27
Views: 75,084
Posted By tululilopo

That's all I need is that wire for a complete...

That's all I need is that wire for a complete manual 4WD conversion.
07-02-2010, 11:52 AM
Replies: 27
Views: 75,084
Posted By tululilopo

Well, that thread didn't tell me where that wire...

Well, that thread didn't tell me where that wire goes. Does it just go to the TCCM? All I need to know it where that wire goes, and the donor car has developed a bees nest. I cannot get in there. If...
07-01-2010, 02:01 PM
Replies: 27
Views: 75,084
Posted By tululilopo

Thanks.

Thanks.
Forum: Builds
06-26-2010, 05:12 PM
Replies: 19
Views: 36,653
Posted By tululilopo

On your shifter display, there is a flat cord...

On your shifter display, there is a flat cord that has 5 wires in it, and it connects the display to the position sensor on the lever. There is another cord that contains 4 wires, and goes somewhere...
06-26-2010, 05:08 PM
Replies: 27
Views: 75,084
Posted By tululilopo

There are two wires coming from the display, they...

There are two wires coming from the display, they are both flat and white, and one contains 4 wires, and the other contains 5. The 5 wire goes down and connects to a position sensor on the shifter...
06-25-2010, 09:15 AM
Replies: 27
Views: 75,084
Posted By tululilopo

Crud, I guess that thing goes to the actuator...

Crud, I guess that thing goes to the actuator then, I really have no clue where it would go.
06-24-2010, 02:30 PM
Replies: 2
Views: 2,473
Posted By tululilopo

Interior lights not working

Well, this is an old problem, and since I'm almost done completely fixing my Blazer, I figure I had better go ahead and take care of it. That problem is, my dome lamp and courtesy lamps do not work....
06-24-2010, 12:12 PM
Replies: 27
Views: 75,084
Posted By tululilopo

Well, I still want an OE looking application. Is...

Well, I still want an OE looking application. Is there a way just to mount the posi lock cable to the shifter itself so I can shift it into 4WD in just one step, as if it were stock, just more...
06-23-2010, 08:50 PM
Replies: 27
Views: 75,084
Posted By tululilopo

Wait, if it's a manual shifter... doesn't the...

Wait, if it's a manual shifter... doesn't the shifter lock the front end? Why do I still need the vacuum thing?
06-23-2010, 12:13 PM
Replies: 27
Views: 75,084
Posted By tululilopo

I went out and looked around, and all my vacuum...

I went out and looked around, and all my vacuum hoses look good, I didn't actually test the actuator, but I looked at it. At least I know where it is now. And I believe the TCCM is mounted on the...
06-22-2010, 03:50 PM
Replies: 27
Views: 75,084
Posted By tululilopo

And this is all just for a temporary fix, I'm...

And this is all just for a temporary fix, I'm still going to do the manual swap whenever I can.
06-22-2010, 03:47 PM
Replies: 27
Views: 75,084
Posted By tululilopo

I think on the older ones the TCCM is somewhere...

I think on the older ones the TCCM is somewhere else. I've pulled my kick panel before and there was some kind of black actuator/valve looking thing, almost looks like the cruise control thing under...
06-22-2010, 12:31 PM
Replies: 27
Views: 75,084
Posted By tululilopo

Where is the encoder motor? And another thing I'm...

Where is the encoder motor? And another thing I'm hearing a lot of people are having problems with is the TCCM. Where is that located? And the vacuum thing is beneath the battery, right?
06-21-2010, 03:50 PM
Replies: 27
Views: 75,084
Posted By tululilopo

And I forgot to mention, with the switch, I can...

And I forgot to mention, with the switch, I can put the car in neutral, and it will go into 4lo, but it won't shift into 4hi at all. Not in neutral, park, or in any gear, but the 4lo works flawlessly...
06-21-2010, 03:46 PM
Replies: 27
Views: 75,084
Posted By tululilopo

Well, I'm kind of picky, and wanted everything to...

Well, I'm kind of picky, and wanted everything to look OE, so to take the place of the 4WD switch, I got a rear defogger switch, and to take the place of the original defogger switch, I got a fog...
06-20-2010, 09:37 PM
Replies: 27
Views: 75,084
Posted By tululilopo

Thank you very much, I'm not sure if I should buy...

Thank you very much, I'm not sure if I should buy a manual transfer case now or just take the shifter and everything back.
06-20-2010, 01:44 PM
Replies: 27
Views: 75,084
Posted By tululilopo

4WD push-button to manual conversion

I've never posted anything on here before, and don't know if I'm the correct category, but I have a question about my 4WD shifter.
I've had problems with my stupid push-button 4WD thing, and became...
07-30-2009, 09:34 PM
Replies: 143
Views: 69,483
Posted By tululilopo

not even kidding... on vortec's like the one in...

not even kidding... on vortec's like the one in urs... thrush dual chamber muffler... u will never hear a better growl from a v6 and some v8's like this is pretty much just the littlest bit quieter...
Showing results 1 to 24 of 24


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands