Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: uncle_egg820
Showing results 1 to 11 of 11
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
08-26-2012, 12:23 PM
Replies: 4
Views: 2,306
Posted By uncle_egg820

ignition switch.

ignition switch.
Forum: 2nd Generation S-series (1995-2005) Tech
08-26-2012, 12:05 PM
Replies: 7
Views: 755
Posted By uncle_egg820

my 97 did the same thing. threw the same codes....

my 97 did the same thing. threw the same codes. rebuilt tranny with no improvement. after noticing several little "quirks" and after further aggravation and lots of research it ended up being the...
Forum: 2nd Generation S-series (1995-2005) Tech
08-13-2012, 06:25 PM
Replies: 3
Views: 1,350
Posted By uncle_egg820

Maybe the catalytic converter, knock on it see if...

Maybe the catalytic converter, knock on it see if it rattles or see if you have a sulfur smell in your exhaust.
Forum: 2nd Generation S-series (1995-2005) Tech
08-13-2012, 05:48 PM
Replies: 10
Views: 1,665
Posted By uncle_egg820

mr_smith in the first pic you have you are...

mr_smith in the first pic you have you are looking at the neutral safety switch. the linkage bracket hangs down from post. in your second pic you show a bracket and shift cable. First hook up your...
Forum: 2nd Generation S-series (1995-2005) Tech
07-30-2012, 11:19 PM
Replies: 9
Views: 2,252
Posted By uncle_egg820

It is still "so far so good", approx. 1000 miles...

It is still "so far so good", approx. 1000 miles later. YEA!
Forum: 2nd Generation S-series (1995-2005) Tech
07-23-2012, 06:48 PM
Replies: 9
Views: 2,252
Posted By uncle_egg820

Well to tell you the truth (swartlkk), it is too...

Well to tell you the truth (swartlkk), it is too lat to not be expensive. See, I got the tranny rebuilt, with all new solenoids of course. Put on a neutral safety switch, just because the old one was...
Forum: 2nd Generation S-series (1995-2005) Tech
07-23-2012, 12:03 AM
Replies: 9
Views: 2,252
Posted By uncle_egg820

still going strong. Shift from 1st to 2nd is a...

still going strong. Shift from 1st to 2nd is a little high on rpms but at least she is shifting on her own again.
Forum: 2nd Generation S-series (1995-2005) Tech
07-14-2012, 08:18 PM
Replies: 9
Views: 2,252
Posted By uncle_egg820

Update, ignition switch is in and, crossing my...

Update, ignition switch is in and, crossing my fingers, first two test drives she is ready to run! Test drives were just around town for about three miles, but there are several stops.
Forum: 2nd Generation S-series (1995-2005) Tech
07-14-2012, 08:15 PM
Replies: 9
Views: 2,252
Posted By uncle_egg820

Yes I have. even disconnected the computer for a...

Yes I have. even disconnected the computer for a while. Doing this made no noticeable change with the exception for the first couple stop-n-go's. I figured it was the computer adjusting. However she...
Forum: 2nd Generation S-series (1995-2005) Tech
07-14-2012, 01:26 PM
Replies: 9
Views: 2,252
Posted By uncle_egg820

confusion, frustration, and aggravation. please help.

I have a 97 blazer 4X4 that has started giving me fits. Anything from a stuck key to limp mode transmission. IT has a "tick" in the fuel gauge when the turn signal is on or when I hit the brakes....
Forum: Lighting & Electrical
07-08-2012, 01:33 PM
Replies: 0
Views: 674
Posted By uncle_egg820

multiple issues creating confusion on 97 4x4 Blazer

Is it possible for a faulty ignition switch to be the cause of transmission fault codes, map, maf, cam, and oxy sensor codes. All along with key removal solenoid in steering, passenger window control...
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands