Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Maynard97
Showing results 1 to 13 of 13
Search took 0.01 seconds.
Forum: Engine & Transmission
10-21-2018, 02:17 PM
Replies: 2
Views: 619
Posted By Maynard97

Many thanks!

Many thanks!
Forum: Engine & Transmission
10-21-2018, 12:05 PM
Replies: 2
Views: 619
Posted By Maynard97

Transfer Case Vacuum Lines

There appear to be three vacuum lines connected to the transfer case on my 1997 4WD Blazer. Can anyone tell me where each of the three lines go?

Thanks
Tom
Forum: Steering, Suspension & Drivetrain
09-04-2018, 08:23 AM
Replies: 4
Views: 744
Posted By Maynard97

Thanks. I believe the noise might be from the...

Thanks. I believe the noise might be from the hub bearing, but, I can't rule out the axle bearing. I do get a little bit of wiggle when the wheel is off the ground - it doesn't seem excessive but I...
Forum: Steering, Suspension & Drivetrain
09-03-2018, 06:59 PM
Replies: 4
Views: 744
Posted By Maynard97

Wheel Bearings

1997 4WD, How do I tell if the front wheel bearings are bad? I hear a left-side front end noise, and feel some slight vibration as well, when turning at highway speeds, such as exiting from an...
Forum: Lighting & Electrical
07-31-2018, 09:50 AM
Replies: 5
Views: 513
Posted By Maynard97

A related question, when I jumper 12 volts from...

A related question, when I jumper 12 volts from the battery directly to the blower motor terminals, the blower motor runs, but the jumper leads get very hot pretty quickly. Is this normal or does it...
Forum: Lighting & Electrical
07-31-2018, 04:16 AM
Replies: 5
Views: 513
Posted By Maynard97

Thank you. When I open the connector, some of...

Thank you. When I open the connector, some of the plastic is actually melted so I am thinking that I want to replace it. How/where would I purchase a replacement?
Forum: Lighting & Electrical
07-30-2018, 07:09 PM
Replies: 5
Views: 513
Posted By Maynard97

Question Connector Over-heating

Hello,

Could anyone tell me what circuits run through the connector in the photo (from my 1997 Blazer)? A couple of the leads get very hot - to the point of actually melting some of the plastic...
Forum: 2nd Generation S-series (1995-2005) Tech
07-23-2016, 01:38 PM
Replies: 4
Views: 476
Posted By Maynard97

Many thanks.

Many thanks.
Forum: 2nd Generation S-series (1995-2005) Tech
07-23-2016, 10:16 AM
Replies: 4
Views: 476
Posted By Maynard97

Question '97 blazer a/c leak

I have a '97 blazer with a noticeable a/c leak at the threaded fitting on the a/c dryer vessel (this threaded connection faces toward the passenger compartment). I can feel the leak blowing with my...
Forum: Audio/Video Electronics
11-21-2007, 12:54 PM
Replies: 4
Views: 675
Posted By Maynard97

RE: OEM Radio

Thanks.
Forum: Audio/Video Electronics
11-21-2007, 12:25 PM
Replies: 4
Views: 675
Posted By Maynard97

OEM Radio

Would it be possible/practical to install a newer OEM radio, say from a 2007 trailblazer, into a 1997 Blazer? Both are double-din. My '97 has the original radio and I like the look and feel of the...
Forum: Steering, Suspension & Drivetrain
10-28-2007, 07:56 PM
Replies: 7
Views: 1,269
Posted By Maynard97

RE: Right Front Squeak

Thanks! I finally got around to trying it and the silicone spray did the trick. Maynard
Forum: Steering, Suspension & Drivetrain
10-17-2007, 07:30 PM
Replies: 7
Views: 1,269
Posted By Maynard97

Right Front Squeak

Hello,

I'm new to the group and I have a problem. I have a '97 LS 4WD Blazer that has a very annoying squeak in the area of the right front suspension. It sounds almost like rubber or a very...
Showing results 1 to 13 of 13


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands