Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Chumba87
Showing results 1 to 8 of 8
Search took 0.00 seconds.
Forum: 1st Generation S-series (1983-1994) Tech
08-20-2012, 10:57 PM
Replies: 2
Views: 7,140
Posted By Chumba87

Check ur iac! I cleaned mine and it helped!

Check ur iac! I cleaned mine and it helped!
Forum: Engine & Transmission
08-20-2012, 10:35 PM
Replies: 9
Views: 2,496
Posted By Chumba87

Ok I haven't check the fuel yet but I replaced...

Ok I haven't check the fuel yet but I replaced the radiator cuz It was clogged enough to make it run hotter then normal! Fixed that problem and it ran a lot better! I noticed when I was checking my...
Forum: Engine & Transmission
08-17-2012, 11:06 PM
Replies: 9
Views: 2,496
Posted By Chumba87

Ya it's tbi! I haven't checked the fuel pressure...

Ya it's tbi! I haven't checked the fuel pressure but I didn't really consider that sense it idles and drives fine until it warms up! But that's something I need to check on! How much psi should it...
Forum: Engine & Transmission
08-17-2012, 05:26 AM
Replies: 9
Views: 2,496
Posted By Chumba87

I have checked for vac leaks and haven't found...

I have checked for vac leaks and haven't found any yet! And are u talking about the throttle possision sensor, idle air control, um I can't think of the others right now!
Forum: Engine & Transmission
08-16-2012, 10:53 PM
Replies: 9
Views: 2,496
Posted By Chumba87

Unhappy Dies when under a load (rebuilt engine)

Ok so to start off I just finished rebuilding my 2.8l in my 87 s10 blazer! Not what I wanted but needed something until I can afford the motor I want! It stalls out after its warmed up! When I first...
Forum: Lighting & Electrical
07-16-2012, 09:30 PM
Replies: 5
Views: 5,000
Posted By Chumba87

Sounds like a bad ground or maybe corroded cable...

Sounds like a bad ground or maybe corroded cable inside somewhere... I would check all grounds first
Forum: Lighting & Electrical
07-16-2012, 10:50 AM
Replies: 2
Views: 518
Posted By Chumba87

Ya if I jump it from the big terminal to the...

Ya if I jump it from the big terminal to the little one it kicks the bendix out but Im not getting power to the little wire when u turn the ignition!
Forum: Lighting & Electrical
07-16-2012, 09:50 AM
Replies: 2
Views: 518
Posted By Chumba87

Starting problem!

Ok for the past week I've been rebuilding my gf 2.8l motor in her 87 s10 blazer! Finally finished after a couple hours each day! I repaired the wiring harness where there were some old wires! Got the...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands