Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Blue Jay
Showing results 1 to 17 of 17
Search took 0.00 seconds.
Forum: Lighting & Electrical
11-08-2013, 08:25 PM
Replies: 6
Views: 4,090
Posted By Blue Jay

I am fighting the same problem, when I get it...

I am fighting the same problem, when I get it figured out will post back.
Forum: Engine & Transmission
08-01-2012, 08:55 PM
Replies: 10
Views: 35,127
Posted By Blue Jay

I would try a mechanical gauge that you know is...

I would try a mechanical gauge that you know is good. Could be a bad sending unit, had that happen on a pickup several years ago, I tore id down and put in all new bearings in and still had the same...
Forum: 2nd Generation S-series (1995-2005) Tech
08-01-2012, 05:56 PM
Replies: 2
Views: 1,017
Posted By Blue Jay

Check the backing plate. On my 03 it was...

Check the backing plate. On my 03 it was seperating and rubbing opn the roter.
Forum: 2nd Generation S-series (1995-2005) Tech
07-20-2012, 11:21 AM
Replies: 3
Views: 998
Posted By Blue Jay

Thanks I have searched for 2 days and did not...

Thanks I have searched for 2 days and did not find that. Must have had the wrong key words.
Forum: 2nd Generation S-series (1995-2005) Tech
07-20-2012, 06:47 AM
Replies: 3
Views: 998
Posted By Blue Jay

Still wondering how to clean the ATF out of the...

Still wondering how to clean the ATF out of the vacume lines?
Forum: 2nd Generation S-series (1995-2005) Tech
07-18-2012, 03:58 PM
Replies: 3
Views: 998
Posted By Blue Jay

Clean Vacume lines?

03 Blazer, 4.3 auto, 4X4 Had a problem on the road that chewed up the gear on the right axle shaft in the front Diff. Reading the post I determined the problem started with the vacuum switch on the...
Forum: 2nd Generation S-series (1995-2005) Tech
02-02-2012, 06:56 PM
Replies: 16
Views: 4,890
Posted By Blue Jay

That would be the PCV valve with a vacume hose...

That would be the PCV valve with a vacume hose attached. Sounds like time for a new one.
Forum: 2nd Generation S-series (1995-2005) Tech
01-14-2012, 08:08 PM
Replies: 17
Views: 7,816
Posted By Blue Jay

A shot in the dark, do you have a trailer hookup?...

A shot in the dark, do you have a trailer hookup? If so check it for green.
Forum: 2nd Generation S-series (1995-2005) Tech
01-08-2012, 03:58 PM
Replies: 7
Views: 2,044
Posted By Blue Jay

I would say the hose is the vent line for the...

I would say the hose is the vent line for the front diff. (a vacuum line would not dead end like that) the plastic cap is a filter to help keep dirt out, Make sure it stays up high to avoid pulling...
Forum: 2nd Generation S-series (1995-2005) Tech
12-26-2011, 05:36 PM
Replies: 13
Views: 2,474
Posted By Blue Jay

I second the shift cable, water getting in and...

I second the shift cable, water getting in and freezing hence it won't move when cold.
Forum: 2nd Generation S-series (1995-2005) Tech
12-15-2011, 04:57 PM
Replies: 11
Views: 10,222
Posted By Blue Jay

Sounds like a leak to me. It could not burn that...

Sounds like a leak to me. It could not burn that much fuel and come close to running right unless you never get out of 2nd gear. Get it scanned for codes and go from there.
GL
Forum: 2nd Generation S-series (1995-2005) Tech
12-14-2011, 04:35 PM
Replies: 1
Views: 620
Posted By Blue Jay

went and bought a new spider today and got it in,...

went and bought a new spider today and got it in, pressure now holds as it should, need some more daylight to finish. The old injectors were a lot of fun to get out.
Forum: 2nd Generation S-series (1995-2005) Tech
12-14-2011, 04:32 PM
Replies: 4
Views: 1,080
Posted By Blue Jay

Just leave it, that is a breather in the end and...

Just leave it, that is a breather in the end and you want it up high so it does not suck water in.
Forum: 2nd Generation S-series (1995-2005) Tech
12-14-2011, 03:01 PM
Replies: 4
Views: 1,080
Posted By Blue Jay

Looks like the vent line for the front diff.

Looks like the vent line for the front diff.
Forum: 2nd Generation S-series (1995-2005) Tech
12-13-2011, 07:53 PM
Replies: 1
Views: 620
Posted By Blue Jay

Another Spider Question

03 Blazer engine code X Fuel pressure falling off after prime, Long story short after getting just about back together did another check, new regulator in can't tell how high as it falls off too...
Forum: 2nd Generation S-series (1995-2005) Tech
12-12-2011, 11:03 AM
Replies: 1
Views: 576
Posted By Blue Jay

Lost Nut

03, 4.3, 4X4 I was trying to find fuel leak in plenamn, had the plastic dome off and was hooking fuel lines back up so I could re-preassure system and the nut on the left side slipped from my...
Forum: 2nd Generation S-series (1995-2005) Tech
12-11-2011, 04:27 PM
Replies: 8
Views: 2,402
Posted By Blue Jay

You have a vacume leak someplace, need to check...

You have a vacume leak someplace, need to check all lines and fittings. Not fun but have to do it.
Showing results 1 to 17 of 17


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands