Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: clone432
Showing results 1 to 27 of 27
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
08-19-2008, 04:02 PM
Replies: 4
Views: 2,171
Posted By clone432

RE: EGR install on '95

That stupid EGR! I have had an intermittant rough idle over the last few years. At its worst the engine light would flash at every stoplight. But right now it seems to be pretty happy though. ...
Forum: 2nd Generation S-series (1995-2005) Tech
08-19-2008, 02:31 PM
Replies: 8
Views: 1,293
Posted By clone432

RE: defroster

I found a pretty monster vac leak in the hose from the back of the intake. now I have great vac pressure to the back of the heater control. But I now can't hold vac pressure when applied manually...
Forum: 2nd Generation S-series (1995-2005) Tech
08-19-2008, 02:19 PM
Replies: 4
Views: 2,171
Posted By clone432

RE: EGR install on '95

As you are looking at it the wire harrness should be on the rightside. I think there is only one way it can be installed if I remember correctly.
Forum: 2nd Generation S-series (1995-2005) Tech
08-18-2008, 10:18 PM
Replies: 8
Views: 1,293
Posted By clone432

RE: defroster

So quick question.

Info: 97 4x4

So where exactly does the HVAC get its source vac? Does the supply line run from the black ball under the hood across the fire wall and through to behind...
Forum: 2nd Generation S-series (1995-2005) Tech
08-18-2008, 10:04 PM
Replies: 15
Views: 3,479
Posted By clone432

RE: Vaccum Supply to vent control

Any update? Mine is no better......:(
Forum: 2nd Generation S-series (1995-2005) Tech
03-03-2008, 02:35 PM
Replies: 2
Views: 937
Posted By clone432

RE: Vacuum heater question

KA3AX (https://blazerforum.com/showProfile.asp?memid=2194),

If you still have your Dash apart can you please snap a picture showing where the actuators are?

Thanks!
Forum: 2nd Generation S-series (1995-2005) Tech
02-14-2008, 10:37 AM
Replies: 15
Views: 3,479
Posted By clone432

Vaccum Supply to vent control

Current situation: Vents stuck in default defrost/floor, with hissing noice when selector is in "floor" mode.

Last night I checked the operation of the vent to floor actuator (Drivers side under...
Forum: 2nd Generation S-series (1995-2005) Tech
12-14-2007, 02:37 PM
Replies: 3
Views: 687
Posted By clone432

RE: New sound, like air pump

Hmmm...since no one answered, maybe I failed to explain.

The sound only occurs when backing up with the brakes applied. When I realease the brake petal the sound (The pump like sounds) stops.
...
Forum: 2nd Generation S-series (1995-2005) Tech
12-11-2007, 11:16 AM
Replies: 4
Views: 3,884
Posted By clone432

RE: 1996 Heater Switch Not working

Thanks for the info swartlkk! Do you happen to know specificly if the accuator that controls the defrost/floor to dash vent can be accessed from the glove box opening? Since I think that is where my...
Forum: 2nd Generation S-series (1995-2005) Tech
12-10-2007, 02:13 PM
Replies: 4
Views: 3,884
Posted By clone432

RE: 1996 Heater Switch Not working

The general concensus on here if you have checked the vac lines behind the controls is that the vac accuator is broken or stuck. I have had the same issue for a while now and need to get it fixed. It...
Forum: 2nd Generation S-series (1995-2005) Tech
12-10-2007, 02:01 PM
Replies: 3
Views: 687
Posted By clone432

New sound, like air pump

The sound only happens when I am backing up and use the brakes, most often when backing out of my driveway on a slight incline. Sounds like a air pump...

I never hear it under other...
Forum: 2nd Generation S-series (1995-2005) Tech
07-17-2007, 02:38 PM
Replies: 6
Views: 1,320
Posted By clone432

RE: Big problems all instruments going haywire

You mentioned that the threads were wore out on the old battery, check for corrosion in the cable heading away from the battery. I was out one day getting gas ,(about 3 months after a side terminal...
Forum: 2nd Generation S-series (1995-2005) Tech
07-17-2007, 02:31 PM
Replies: 5
Views: 3,018
Posted By clone432

RE: Multifunction switch-without pulling wheel?

I took my airbag and wheel off when I replaced mine. The column cover is pretty darn hard and would increase the time of the task by more than it takes to take the wheel and airbag off. Just make...
Forum: 2nd Generation S-series (1995-2005) Tech
07-14-2007, 02:23 PM
Replies: 8
Views: 968
Posted By clone432

RE: Unique A/C problem

Take your vac gage and check the Grey line on the vac harrness on the back of your HVAC contol on the dash. If you have good engine vac there then the problem should reside between the hvac control...
Forum: 2nd Generation S-series (1995-2005) Tech
07-11-2007, 02:30 PM
Replies: 5
Views: 2,680
Posted By clone432

RE: Multifunction switch

What year blazer do you have? I bought a multi switch off ebay for around $100. When I compared to the old it was exactly the same short of the GM logos. Its not a bad job other than taking...
Forum: 2nd Generation S-series (1995-2005) Tech
07-11-2007, 02:24 PM
Replies: 7
Views: 6,198
Posted By clone432

RE: Removing 3rd Spark plug and Steering Shaft??

I have never had to make a tool or remove anything, once I figured out that if you jack the body up to releve the suspension pressure it gives you just enough room to use a wobbly to get on the plug....
Forum: 2nd Generation S-series (1995-2005) Tech
06-11-2007, 02:53 PM
Replies: 1
Views: 1,263
Posted By clone432

RE: multifunction switch

I would check and make sure all the wire connections were fastened securely. I just changed mine on my '95 and it was pretty hard to get to a couple, especially those under the dash.

Did you...
Forum: 2nd Generation S-series (1995-2005) Tech
06-11-2007, 02:44 PM
Replies: 7
Views: 1,376
Posted By clone432

RE: '95 Service Engine, Rough idle

I have a 95 blazer with the TBI 4.3, and have fought the rough idle...haven't been able to beat it. Though it has become less frequent!
Forum: 2nd Generation S-series (1995-2005) Tech
04-25-2007, 06:42 PM
Replies: 5
Views: 1,003
Posted By clone432

RE: No Dash Air from Panel Vents. Help

I have not had a chance to check the "T", but I have replaced the HVAC head unit. Did not fix the problem and there was not fluid in the ashtray. Thanks though Mark!

Is there a good way to test...
Forum: 2nd Generation S-series (1995-2005) Tech
04-23-2007, 12:19 PM
Replies: 5
Views: 1,003
Posted By clone432

RE: No Dash Air from Panel Vents. Help

Thanks! I will give that a shot tonight.
Forum: 2nd Generation S-series (1995-2005) Tech
04-18-2007, 05:31 PM
Replies: 5
Views: 1,003
Posted By clone432

No Dash Air from Panel Vents. Help

I have a 95 chev Balzer. I can't get the air to exit the panel vents, it is stuck through the defroster and floor vents. I hear the hiss of air escaping from behind the dash. I have checked/changed...
Forum: 2nd Generation S-series (1995-2005) Tech
03-13-2007, 06:09 PM
Replies: 25
Views: 2,016
Posted By clone432

RE: Looking for closest CLIFF

OK, forgive me if this has been suggested....I started skimming posts.

have you ever had a battery fail....by fail leak acid at the post? I had this happen and I was left stranded for a couple...
Forum: 2nd Generation S-series (1995-2005) Tech
02-13-2007, 05:57 PM
Replies: 32
Views: 12,102
Posted By clone432

RE: Temperature Control Selection Switch PROBLEM??

I have the same issue in my '95. I have swtched out the heat selector and the vac hose out, but did nothing to fix the problem. I tested the vacuum at the ball under the hood and still has good...
Forum: 2nd Generation S-series (1995-2005) Tech
02-06-2007, 05:51 PM
Replies: 9
Views: 9,653
Posted By clone432

RE: Exhaust on 4.3 Vortec Blazer

I installed a "Flowmaster Clone" and the sounddidn't change, but then I had a plugged cat. conv. So I installed a "high-flow" cat and the sound improved dramaticaly.

At least in my rig. '95 4.3
Forum: 1st Generation S-series (1983-1994) Tech
02-02-2007, 07:35 PM
Replies: 5
Views: 752
Posted By clone432

RE: injecters blazer 95

The shop is right its one expensive part to replace. If your a bit handy and not afraid to pop the throttle body apart it isn't too hard. I think that it took me about 2-3 hours and I was really...
Forum: 2nd Generation S-series (1995-2005) Tech
02-01-2007, 05:45 PM
Replies: 1
Views: 1,466
Posted By clone432

No air/heat from front vents.

95 blazer

One day the air stopped flowing through the front vents, it is now stuck on the floor and window vent. I have checked and replaced the heater controls and vac line from the back and...
Forum: General Chat
01-29-2007, 05:26 PM
Replies: 244
Views: 180,758
Posted By clone432

RE: A list of common annoying S-10 Blazer quirks.

List of issues:

1. Rough idle. One light perfect and smoot, next like the motor is going to drop out.
2. NO 4hi....typical of most I think
3. Front brakes wear so fast
4. Factory radio...
Showing results 1 to 27 of 27


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands