Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: 1badblaze
Showing results 1 to 20 of 20
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
07-09-2009, 09:36 PM
Replies: 124
Views: 42,643
Posted By 1badblaze

My guess is crank bearings or tone rine for the...

My guess is crank bearings or tone rine for the crank sensor
I have the same problem on my 95 but it doesn't throw any codes and its
Very intermintent
Forum: Lifting Tech
02-22-2009, 10:35 PM
Replies: 5
Views: 2,963
Posted By 1badblaze

RE: 31s on a stock blazer

wich type of lift should i get a bl lift or a suspension lift. i was gonna buy a suspension lift first.
Forum: 2nd Generation S-series (1995-2005) Tech
02-22-2009, 10:18 PM
Replies: 1
Views: 1,030
Posted By 1badblaze

95 blazer rough idle

i have a junkyard motor in my blazer and it has a rough idle but no cel. should it be smooth at idle as i know it has a balance shaft. im worried the valve guides are bad as the last motor had oval...
Forum: Lifting Tech
02-22-2009, 10:10 PM
Replies: 5
Views: 2,963
Posted By 1badblaze

31s on a stock blazer

i have started buying 31s for my 2dr 95 blazer. its in stock form and im gonna add a lift. but not yet. i need to know if i can put these tires on and drive it without too much problems. will it rub...
Forum: 2nd Generation S-series (1995-2005) Tech
01-28-2009, 03:45 PM
Replies: 24
Views: 30,087
Posted By 1badblaze

RE: Runs great when cold, stalls when warm

u might want to pull the upper plenum off and pull the injectors out but leave them plugged in to the fuel rail then turn the key on then turn it off and see if fuel leaks from the injectors. if that...
Forum: 2nd Generation S-series (1995-2005) Tech
12-11-2008, 09:36 PM
Replies: 19
Views: 8,040
Posted By 1badblaze

RE: I had the same problem....

when diagnosing a misfire it is helpful to do a compresion tes on the engine when it is hot. everything was replaced on mine from injection spiders to fuel pumps to igntion coils etc. turns out that...
Forum: 2nd Generation S-series (1995-2005) Tech
11-21-2008, 02:39 AM
Replies: 4
Views: 537
Posted By 1badblaze

RE: brakes

The rear are shoes and drums I wish I had rear disc brakes. I was think maybe a bad modulater valve but ill check the proportioning valve
Forum: 2nd Generation S-series (1995-2005) Tech
11-20-2008, 08:21 PM
Replies: 4
Views: 537
Posted By 1badblaze

RE: brakes

There is a little squealing coming from the rear when I stop. Hydraulics are good. Been doing since I bought it. I paid 600 for it and replaced the heads as it had sticking valves and seats not...
Forum: 2nd Generation S-series (1995-2005) Tech
11-20-2008, 07:58 PM
Replies: 4
Views: 537
Posted By 1badblaze

brakes

i have a 95 blazer 2 dr4x4. the problem is that the front brakes do all the stopping. and as soon as u hit the brakes they will put u thru the winsheild. its like the back brakes are not working at...
Forum: 2nd Generation S-series (1995-2005) Tech
11-20-2008, 07:22 PM
Replies: 2
Views: 743
Posted By 1badblaze

fender flares

will zr2 fender flares fit on my 95 2dr blazer
Forum: 2nd Generation S-series (1995-2005) Tech
09-17-2008, 07:08 PM
Replies: 5
Views: 1,310
Posted By 1badblaze

RE: Random Misfire

after replacing ev erything on my blazer i found my p0300 was sticking valves on cyl 2 and 4 i caught it with a vacumn gauge and multiple compresion readings. i waitecd till the missing started and...
Forum: Steering, Suspension & Drivetrain
08-28-2008, 12:41 AM
Replies: 2
Views: 1,642
Posted By 1badblaze

95 4wd vacumn hose for 4wd

i have a 95 4wd and at the vacumnn actuater on the transfer case there is a line that goes to a t connection.two of the lines stay at the transfer case area.the third goes towards the front of the...
Forum: 2nd Generation S-series (1995-2005) Tech
08-28-2008, 12:01 AM
Replies: 4
Views: 2,151
Posted By 1badblaze

RE: Starving for fuel...?

if there was a wire harness that was available when you bought the fuel pump u should of bought it. but u need to check fuel pressure before and after start up and it helps to know voltage at the...
Forum: Performance & Brainstorming
08-27-2008, 11:43 PM
Replies: 27
Views: 51,829
Posted By 1badblaze

RE: Converting to an electric fan

didnt think about that u just put the load somewhere else, the alternator, besides i hear the roar i know its cooling
Forum: Performance & Brainstorming
08-27-2008, 11:22 PM
Replies: 27
Views: 51,829
Posted By 1badblaze

RE: Converting to an electric fan

but it takes power from the crankshaft via the belt to turn the fan why wouldnt u gain from taking it off
Forum: 2nd Generation S-series (1995-2005) Tech
08-25-2008, 12:37 PM
Replies: 7
Views: 4,237
Posted By 1badblaze

RE: voltage drop

i once put 5 alts on my sisters car from autozone when i finally had it and went and got my money back. there alts suck. wilcox, naapa, koi etc are good stay away from the discount chains they suck
Forum: 2nd Generation S-series (1995-2005) Tech
08-25-2008, 12:32 PM
Replies: 4
Views: 1,417
Posted By 1badblaze

RE: 95 blazer 4wd 2 dr 4 high not working

when i remove the fuse and push 4hi it blinks then goes back to 2hi. i can get 4 low but it doesnt shift thru the gears when moving forward. halfass 4lo. what and where isthe encoder motor position...
Forum: 2nd Generation S-series (1995-2005) Tech
08-25-2008, 12:26 PM
Replies: 1
Views: 1,455
Posted By 1badblaze

RE: A/C Leaking from Front of Compressor

there are numerous manufactuers with this problem. your best bet would be to find a company that rebuilds them and knows about the problem because you will end up with the same thing over and over. i...
Forum: 2nd Generation S-series (1995-2005) Tech
08-24-2008, 08:42 PM
Replies: 4
Views: 1,417
Posted By 1badblaze

95 blazer 4wd 2 dr 4 high not working

hi all this is my first post. i have a 95 2dr 4x4 and love it.
when i push the 4hi button it flashes then goes back to 2hi. however 4low seems to work. i have no knowledge of how this system works...
Showing results 1 to 20 of 20


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands