Blazer Forum - Chevy Blazer Forums

Search: Posts Made By: JIMFILI

Showing results 1 to 18 of 18
Search took 0.00 seconds.

Forum: Steering, Suspension & Drivetrain

07-03-2016, 04:59 PM

Replies: 4

Rear bearing

Views: 709

Posted By JIMFILI

For some reason the seal isnt sealing, it pops in...

For some reason the seal isnt sealing, it pops in but comes out with no resistance at all, if i use some rtc sealant would that mess any thing up, because the seal is good on the shaft it just where...

Forum: Steering, Suspension & Drivetrain

06-29-2016, 06:42 PM

Replies: 4

Rear bearing

Views: 709

Posted By JIMFILI

Rear bearing

I just recently had to replace rear bearing, i got it changed and all and im leaking gear oil out of driver side rear, the new seal matched the old one, so dont know why it it's not sealing. Also i...

Forum: 2nd Generation S-series (1995-2005) Tech

02-19-2015, 12:18 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

I'm having trouble pumping gas I get 3/4 of a...

I'm having trouble pumping gas I get 3/4 of a gallon and it clicks off like it's full but it's not

Forum: 2nd Generation S-series (1995-2005) Tech

01-18-2015, 04:39 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

Was the fuel pump. What rpms should it idle at, ...

Was the fuel pump. What rpms should it idle at, right now I'm at 600 rpms at idle

Forum: 2nd Generation S-series (1995-2005) Tech

01-03-2015, 09:39 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

Cleared codes and P0300 comes up, reading in...

Cleared codes and P0300 comes up, reading in Haynes manual that a faulty egr valve can cause a misfire code to pop up, was going to get one from junk yard to save $.

Forum: 2nd Generation S-series (1995-2005) Tech

01-03-2015, 09:34 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

Changed the pcv valve, spark plugs, cap and...

Changed the pcv valve, spark plugs, cap and rotor, fuel pressure regulator, spark plug wires,and ignition coil.

Forum: 2nd Generation S-series (1995-2005) Tech

01-03-2015, 09:30 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

One of the prongs was bent for the injectors and...

One of the prongs was bent for the injectors and not getting a connection

Forum: 2nd Generation S-series (1995-2005) Tech

01-03-2015, 06:08 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

Error code

Got code 200 solved now getting code P0300, think it's the egr valve, when unplugged the vehicle runs the same as if plugged in.

Forum: 2nd Generation S-series (1995-2005) Tech

12-26-2014, 09:28 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

Will try, thanks capt.

Will try, thanks capt.

Forum: 2nd Generation S-series (1995-2005) Tech

12-26-2014, 07:15 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

Could that change after I changed the regulator,...

Could that change after I changed the regulator, also I think it back fires under the upper pent-up when it gets too much gas

Forum: 2nd Generation S-series (1995-2005) Tech

12-26-2014, 06:23 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

I did when having starting problems but haven't...

I did when having starting problems but haven't since I replaced the regulator, it starts on first try now but wants to stall when I press the gas.

Forum: 2nd Generation S-series (1995-2005) Tech

12-26-2014, 05:41 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

It was the regulator starts fine now

It was the regulator starts fine now

Forum: 2nd Generation S-series (1995-2005) Tech

12-26-2014, 04:50 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

Blazer starts but runs rough

My blazer starts but runs really rough and when given gas it wants to stall, I adjusted the idle but doesn't help

Forum: 2nd Generation S-series (1995-2005) Tech

12-01-2014, 05:44 AM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

By cranks I mean turns over and won't start and...

By cranks I mean turns over and won't start and run, but when it does finally start it runs fine

Forum: 2nd Generation S-series (1995-2005) Tech

11-30-2014, 03:53 PM

Replies: 22

Having trouble starting 2002 blazer

Views: 2,485

Posted By JIMFILI

Having trouble starting 2002 blazer

My blazer takes 2-10 times trying to get it started before it finally cranks, I have changed plug wires, plugs, distributor cap and rotor, starting coil, and had battery, alternator, and starter...

Forum: Engine & Transmission

10-27-2013, 12:37 PM

Replies: 6

2002 Blazer

Views: 673

Posted By JIMFILI

stayed in one gear and wouldn't shift now it...

stayed in one gear and wouldn't shift now it shifts but starts in third rather than first

Forum: Engine & Transmission

10-27-2013, 10:12 AM

Replies: 6

2002 Blazer

Views: 673

Posted By JIMFILI

the transmission was in limp mode and the error...

the transmission was in limp mode and the error code came up for the solenoids, after replacing them I had the code cleared.

Forum: Engine & Transmission

10-26-2013, 07:06 PM

Replies: 6

2002 Blazer

Views: 673

Posted By JIMFILI

2002 Blazer

I have a 2002 Chevy Blazer 4x4 and replaced both shift solenoids and now the transmission starts off in third gear, but i can manually start it in first and shift through the first three gears no...

Showing results 1 to 18 of 18

Search Results