Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: Gmas95
Showing results 1 to 29 of 29
Search took 0.01 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
10-21-2014, 07:39 AM
Replies: 11
Views: 3,464
Posted By Gmas95

Have you hooked up a mech gauge to see if the...

Have you hooked up a mech gauge to see if the pressure is actually low? I would do that before changing any parts.
Forum: 2nd Generation S-series (1995-2005) Tech
10-07-2014, 02:47 PM
Replies: 5
Views: 2,164
Posted By Gmas95

Just an Update to this, I replaced the spider...

Just an Update to this, I replaced the spider unit and the problem has been resolved. I had a 100 miles on the first replacement one and it started causing a misfire in cylinder 5. Unfortunately...
Forum: 2nd Generation S-series (1995-2005) Tech
09-25-2014, 04:18 PM
Replies: 5
Views: 2,164
Posted By Gmas95

The spider unit was just purchased in may so I...

The spider unit was just purchased in may so I have a warranty replacement coming, figured mine as well since no cost to swap it out.

I have an OBD2 connector in the truck, but I dont think it is...
Forum: 2nd Generation S-series (1995-2005) Tech
09-24-2014, 03:18 PM
Replies: 5
Views: 2,164
Posted By Gmas95

Anyone have any input?

Anyone have any input?
Forum: 2nd Generation S-series (1995-2005) Tech
09-23-2014, 10:04 AM
Replies: 5
Views: 2,164
Posted By Gmas95

Misfire, Possible P0305 need some help.

I have a 1995 4.3 Blazer , pulled the engine due to leaking core plugs and replaced a ton of other stuff while in there.

Now 100 miles after getting it back together she has a misfire at idle....
Forum: 2nd Generation S-series (1995-2005) Tech
06-18-2014, 08:41 PM
Replies: 4
Views: 2,648
Posted By Gmas95

I have pryed on it still won move enough, I am...

I have pryed on it still won move enough, I am just trying to move it to put the exhaust manifold on.
Forum: 2nd Generation S-series (1995-2005) Tech
06-17-2014, 07:45 PM
Replies: 4
Views: 2,648
Posted By Gmas95

Intermediate Steering shaft. Help!

I have removed the bolt at the bottom that tightens the rag joint to the steering gear input shaft. I cannot get the shaft to lift off the steering gear though. I have searched and it just says to...
Forum: 2nd Generation S-series (1995-2005) Tech
05-08-2014, 08:30 PM
Replies: 27
Views: 3,894
Posted By Gmas95

Yea, have the starter tested for draw while it is...

Yea, have the starter tested for draw while it is in the vehicle, I think autozone does this, or a volt meter with an amp clamp.
Forum: 2nd Generation S-series (1995-2005) Tech
05-08-2014, 08:24 PM
Replies: 9
Views: 1,085
Posted By Gmas95

Guessing your problem is how you end up throwing...

Guessing your problem is how you end up throwing money at it. You just have to do the right tests and diagnose the problem and replace what has failed.

First of all, is the check engine light on?...
Forum: 2nd Generation S-series (1995-2005) Tech
05-08-2014, 03:59 PM
Replies: 4
Views: 1,485
Posted By Gmas95

I am pulling the motor, Removed the torque...

I am pulling the motor, Removed the torque converter cover and was able to view the 2 freeze plugs behind the flexplate. 1 is leaking 1 is fine. The truck only has 91k on it and has been garage kept...
Forum: 2nd Generation S-series (1995-2005) Tech
05-06-2014, 08:40 PM
Replies: 4
Views: 1,485
Posted By Gmas95

This is a picture of the freeze plug, this is why...

This is a picture of the freeze plug, this is why I am pulling the engine. The two in front are leaking and both sides by the engine mounts are leaking. I figure the two in the bell housing are also...
Forum: 2nd Generation S-series (1995-2005) Tech
05-04-2014, 08:09 PM
Replies: 4
Views: 1,485
Posted By Gmas95

Minor overhaul to 95 "w" Blazer.

Getting ready to pull the engine due to freeze plugs leaking. Going to repair what is needed. So far I plan on doing the following.

-Freeze Plugs
-Spider Injection unit, 1 year on new one and 3...
Forum: 2nd Generation S-series (1995-2005) Tech
04-28-2014, 06:32 PM
Replies: 5
Views: 874
Posted By Gmas95

Sounds like you both have a fuel leak, do a...

Sounds like you both have a fuel leak, do a pressure test to know for sure. I had a leaking fuel line from the sending unit to the filter. Repaired that and still had a hard start when warm, smelled...
Forum: 2nd Generation S-series (1995-2005) Tech
04-22-2014, 04:04 PM
Replies: 6
Views: 7,085
Posted By Gmas95

You need to isolate the leak. Is this florescent...

You need to isolate the leak. Is this florescent dye you are using? You mention seeing dye on the compressor, is that in the back around the lines or somewhere else on the compressor? A/C work is...
Forum: 2nd Generation S-series (1995-2005) Tech
04-22-2014, 03:51 PM
Replies: 35
Views: 4,274
Posted By Gmas95

Have you had it back to the shop to have them...

Have you had it back to the shop to have them look at it ? Do you have a check engine light ?
Forum: 2nd Generation S-series (1995-2005) Tech
04-22-2014, 03:46 PM
Replies: 4
Views: 5,697
Posted By Gmas95

Think i Found the problem, the float fell off the...

Think i Found the problem, the float fell off the sending unit. Serves me right i suppose for buy a lower cost aftermarket one from Autozone. I am hoping when I have a good float in there the gauge...
Forum: 2nd Generation S-series (1995-2005) Tech
04-20-2014, 12:08 PM
Replies: 35
Views: 4,274
Posted By Gmas95

Did you replace the flex plate or torque...

Did you replace the flex plate or torque converter?
Forum: 2nd Generation S-series (1995-2005) Tech
04-20-2014, 12:04 PM
Replies: 2
Views: 642
Posted By Gmas95

Do you hear the Fuel pump when you put the key to...

Do you hear the Fuel pump when you put the key to the on position? You should here it for 3 seconds. If you do not hear it, check to make sure it is getting voltage to the sending unit.
Forum: 2nd Generation S-series (1995-2005) Tech
04-20-2014, 11:58 AM
Replies: 4
Views: 5,697
Posted By Gmas95

Fuel gauge Question.Stuck past full.

I replaced sending unit and the fuel lines from tank to filter and the return line. May have over filled the tank afterwards. Now, the fuel gauge is stuck at the 3 clock position which is past full....
Forum: 2nd Generation S-series (1995-2005) Tech
04-01-2013, 09:17 PM
Replies: 3
Views: 1,073
Posted By Gmas95

Grandmas 95 Restore!

I have my grandmas 95 LT 4wd, 90k on the clock. Its been sitting in my garage for the winter and has spent about 70-80% of its life kept in a garge but has been through every winter. Does not have...
Forum: General Chat
09-20-2011, 07:02 PM
Replies: 3
Views: 616
Posted By Gmas95

Tires I am planning on soon, Currently running...

Tires I am planning on soon, Currently running the Lardeo Uniroyal which have been great tires. They have about 5/32nds left on them. They are from 2001 though and have a little dry rot.PLanning on...
Forum: General Chat
09-19-2011, 09:25 PM
Replies: 3
Views: 616
Posted By Gmas95

Winter is coming Maintenance time, Looking for suggestions.

I have a 1995 Blazer, has 88k miles.Trying to get her ready for another winter, doing a lot of maintenance trying to get the truck 100% here's what I have done so far and am about to do.

Done:...
Forum: Paint, Body, & Interior
09-15-2011, 07:14 PM
Replies: 2
Views: 929
Posted By Gmas95

Has anyone tried either of these two paints and...

Has anyone tried either of these two paints and can recommend one over the other? Mostly concerned about color match.

LMC Truck Parts - Page 102...
Forum: Engine & Transmission
09-13-2011, 08:56 PM
Replies: 15
Views: 1,613
Posted By Gmas95

Make sure you slightly kick it, dont got doing...

Make sure you slightly kick it, dont got doing any more damage:icon_razz:
Forum: Engine & Transmission
09-13-2011, 08:27 PM
Replies: 15
Views: 1,613
Posted By Gmas95

Can be lots of things unfortunately , Try...

Can be lots of things unfortunately , Try checking spark from all 6 wires, Can just pull one plug then hook it to each wire.
Check to see if the plug smells like gas also, is wet or has black soot...
Forum: Engine & Transmission
09-13-2011, 08:16 PM
Replies: 15
Views: 1,613
Posted By Gmas95

So right now it is basically cranking over, not...

So right now it is basically cranking over, not firing at all and even when you spray starter fluid it does not fire or attempt to fire. When you turn the key off it sputters like it is chugging? Is...
Forum: Engine & Transmission
09-13-2011, 07:29 PM
Replies: 15
Views: 1,613
Posted By Gmas95

Any signs of small animals? They like to eat...

Any signs of small animals? They like to eat wires. Is it cranking fast, does it spudder, or try to fire at all? Try kicking the gas tank, it sometimes will get a failing Fuel pump to get going.
Forum: Engine & Transmission
09-13-2011, 07:11 PM
Replies: 15
Views: 1,613
Posted By Gmas95

Go to your local Harbor Frieght and get a fuel...

Go to your local Harbor Frieght and get a fuel pressure gauge usually less then $20. Test the fuel pressure.


Verify, Cranking, Fuel, Spark and Compression. Is the best way to start a No-start...
Forum: Paint, Body, & Interior
09-10-2011, 07:05 PM
Replies: 2
Views: 929
Posted By Gmas95

Need help Finding Factory interior paint

Hello, I have a 1995 blazer, it is Deep red or I guess maroon with tan/beige interior, Can any one help me or maybe show a link where i can get a very close factory interior paint, i have a few faded...
Showing results 1 to 29 of 29


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands