Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: 1blkblazer422
Showing results 1 to 34 of 34
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
06-22-2009, 03:04 PM
Replies: 2
Views: 1,563
Posted By 1blkblazer422

thanks

thanks
Forum: 2nd Generation S-series (1995-2005) Tech
06-21-2009, 03:47 PM
Replies: 2
Views: 1,563
Posted By 1blkblazer422

Harmonic balancer ?

I replaced my Harmonic balancer yesterday due to it moving sideways. Are there torque specs for the pulley? It seemed nice and straight yesterday while the engine was running now it is slightly...
Forum: Engine & Transmission
05-03-2009, 07:31 PM
Replies: 16
Views: 37,601
Posted By 1blkblazer422

Both solenoids read around 21 ohms and with key...

Both solenoids read around 21 ohms and with key on they are getting voltage. Any thing else to look for? I was looking on google for some suggestions and it said that there is a fuse for the...
Forum: Engine & Transmission
05-02-2009, 05:09 PM
Replies: 16
Views: 37,601
Posted By 1blkblazer422

I also pulled up codes from the PCM and I had no...

I also pulled up codes from the PCM and I had no tranny codes. I had a p0102 MAF circuit low and a engine misfire code.
Forum: Engine & Transmission
05-02-2009, 04:52 PM
Replies: 16
Views: 37,601
Posted By 1blkblazer422

I dropped the pan today and removed the 2-3...

I dropped the pan today and removed the 2-3 solenoid. The seal appears to be fine and I am not seeing and sediment around the valve. I also removed the 1-2 to compare them. Is there a way to test if...
Forum: Engine & Transmission
04-30-2009, 08:39 PM
Replies: 16
Views: 37,601
Posted By 1blkblazer422

Ok thanks im gonna drop the pan this weekend.

Ok thanks im gonna drop the pan this weekend.
Forum: Engine & Transmission
04-26-2009, 09:44 AM
Replies: 16
Views: 37,601
Posted By 1blkblazer422

Ok so im gonna drop the pan and check out the...

Ok so im gonna drop the pan and check out the wiring. Does anyone have a picture or can tell me where the 2-3 shift solenoid is located? Also if the solenoid was the problem would it have a code for...
Forum: Engine & Transmission
04-25-2009, 09:55 PM
Replies: 16
Views: 37,601
Posted By 1blkblazer422

It was a guy I worked with that did it. I pulled...

It was a guy I worked with that did it. I pulled the tranny and had him rebuild it then I put it back in. Is it just weird timing that right after I put spark plug wires in this happened?
Forum: Engine & Transmission
04-25-2009, 07:07 PM
Replies: 16
Views: 37,601
Posted By 1blkblazer422

Sorry I meant that I had a cracked spark plug...

Sorry I meant that I had a cracked spark plug wire and replaced all my spark plug wires. The tranny has no HD stuff just stock. Thanks
Forum: Engine & Transmission
04-25-2009, 05:44 PM
Replies: 16
Views: 37,601
Posted By 1blkblazer422

Rebuilt trans now has no 3rd or 4th gear.

I recently had my transmission rebuilt about 3 months ago on my 98 Blazer 4wd. Since the rebuild I have put about 2000 miles on the tranny. Now the truck will shift from 1-2 no problem at all but...
Forum: Engine & Transmission
04-05-2009, 08:07 PM
Replies: 4
Views: 1,148
Posted By 1blkblazer422

Try spraying water on the engine and see if it...

Try spraying water on the engine and see if it stalls or idles rougher. I have the same issue and now im thinkin its just a cracked wire somewhere because my engine almost stalls when sprayed. Could...
Forum: Engine & Transmission
04-05-2009, 08:01 PM
Replies: 15
Views: 1,822
Posted By 1blkblazer422

I cleaned the EGR today and got the new gasket...

I cleaned the EGR today and got the new gasket with the screen in it. Also replaced fuel filter and cleaned MAF sensor. Same result as before with the rough idle and bucking under TCC lockup. I then...
Forum: Engine & Transmission
03-31-2009, 09:29 PM
Replies: 15
Views: 1,822
Posted By 1blkblazer422

I have the same problem with my 98 Blazer 4.3....

I have the same problem with my 98 Blazer 4.3. Mine happens at low rpms under TCC lockup with steady pedal. It spudders then when I give it gas and unlock the tcc its fine. It also kinda hesitates...
Forum: Engine & Transmission
01-17-2009, 10:39 PM
Replies: 2
Views: 674
Posted By 1blkblazer422

RE: Replaced B1S1 O2 Still get same codes

Thanks for the help I will troubleshoot through the charts.
Forum: Engine & Transmission
01-15-2009, 04:34 PM
Replies: 2
Views: 674
Posted By 1blkblazer422

Replaced B1S1 O2 Still get same codes

I have a 1998 Blazer and had two codes in the PCM a P0135 abd P0146. I was searching the forum and read how common the 146 code was so I was gonna deal with that code later. The other code was B1S1...
Forum: Steering, Suspension & Drivetrain
12-24-2008, 10:55 PM
Replies: 7
Views: 19,304
Posted By 1blkblazer422

RE: Rubbing noise in front end only in 2wd not 4wd

Mine hasnt done it in 2 weeks then today it did it again and i went from 2wd to 4wd and back to 2wd and now its fine again. I dont know what the problem is. Even though switching it back and forth...
Forum: Steering, Suspension & Drivetrain
12-14-2008, 02:47 PM
Replies: 1
Views: 578
Posted By 1blkblazer422

RE: Weird noise one day and magically gone?

I have the SAME exact problem as you. It sounds like a playing card you put in your bike tire as a kid to make a cool sound. I put it in 4wd and the noise went away then in 2wd it came back. I took...
Forum: Steering, Suspension & Drivetrain
12-14-2008, 12:19 PM
Replies: 7
Views: 19,304
Posted By 1blkblazer422

Rubbing noise in front end only in 2wd not 4wd

I have a 1996 s10 Blazer 4wd that is making a wierd rubbing noise in the front end when in 2wd. I looked around to see if anything was stuck or rubbing but could see nothing visually. When I put the...
Forum: Engine & Transmission
10-09-2008, 10:16 PM
Replies: 3
Views: 605
Posted By 1blkblazer422

96 Tranny in a 98?

Will a 1996 transmission out if a blazer fit in a 98 blazer? The are both 4wd.
Forum: Paint, Body, & Interior
08-28-2008, 10:02 PM
Replies: 2
Views: 1,533
Posted By 1blkblazer422

RE: Fenders,rad support and bumper as 1 piece?

Got the fender and rad support off in 1 piece. Thanks
Forum: Paint, Body, & Interior
08-24-2008, 02:32 PM
Replies: 2
Views: 1,533
Posted By 1blkblazer422

Fenders,rad support and bumper as 1 piece?

Can I take the fenders, rad support, and the bumper of my 96 Blazer as one piece?
Forum: Engine & Transmission
07-23-2008, 06:32 AM
Replies: 2
Views: 1,309
Posted By 1blkblazer422

1996 Blazer with seized engine ?

I have a 1996 4 door Blazer with a seized motor in it. I have a couple questions. Would it be worth it to you guys to replace the engine or part it out? Also if I replace the engine how bad would the...
Forum: Paint, Body, & Interior
07-23-2008, 05:55 AM
Replies: 2
Views: 931
Posted By 1blkblazer422

Do 96 body parts fit 98s?

Will a front fender,hood,and front bumper from a 4 door1996 Blazer fit a 1998 2 door Blazer? I know the grills and headlights arent interchagable but are the other body parts? Thanks
Forum: Paint, Body, & Interior
06-12-2008, 09:16 AM
Replies: 1
Views: 660
Posted By 1blkblazer422

Diff between 2WD or 4WD Lower plastic fascia

I have a 98 4wd Blazer that needs a lower Plastic fascia replaced. I have one for a 98 2WD. Will this fit up to it? The holes seem different. I am goin to need a front bumper as well so should I buy...
Forum: 2nd Generation S-series (1995-2005) Tech
02-18-2008, 02:23 PM
Replies: 3
Views: 1,000
Posted By 1blkblazer422

RE: 4x4 problem with lots of info

So I bought the brand new module and now all the ranges on the switch work but everything but 2 hi blinks when I select them. So I went looking under the hood and finally found the problem. The...
Forum: 2nd Generation S-series (1995-2005) Tech
02-06-2008, 06:12 PM
Replies: 3
Views: 1,000
Posted By 1blkblazer422

RE: 4x4 problem with lots of info

I put the new encoder motor in and get the same problem. I guess im gonna have to go and buy the new module and pray thats it because I have gone through everything else.
Forum: 2nd Generation S-series (1995-2005) Tech
02-03-2008, 01:49 PM
Replies: 3
Views: 1,000
Posted By 1blkblazer422

4x4 problem with lots of info

The main problem here is sometimes the 4wd switch will light up with no service 4wd light and sometimes it will not light up with a service 4wd light. Ihave 2TCCMs.TheoriginalTCCM when in I get no...
Forum: 2nd Generation S-series (1995-2005) Tech
01-30-2008, 08:40 AM
Replies: 12
Views: 14,067
Posted By 1blkblazer422

RE: Rear brakes don't work?

I stomped on my brakes the other day and the brake light went off. The pedal felt a little better but when I stomped on the pedal hard the light would come on then go off when I let of the pedal. The...
Forum: 2nd Generation S-series (1995-2005) Tech
01-24-2008, 03:22 PM
Replies: 1
Views: 698
Posted By 1blkblazer422

Front axels ?

On a 2001 Blazer I purchased I noticed that it had a bad humming noise and I found the problem to be a bad wheel bearing. As I was going to put the tire on I noticed fresh axel grease spitting out on...
Forum: 2nd Generation S-series (1995-2005) Tech
01-24-2008, 03:15 PM
Replies: 12
Views: 14,067
Posted By 1blkblazer422

RE: Rear brakes don't work?

Thanks I will try that this weekend.
Forum: 2nd Generation S-series (1995-2005) Tech
01-24-2008, 08:28 AM
Replies: 12
Views: 14,067
Posted By 1blkblazer422

RE: Rear brakes don't work?

I have the same problem with my 96. The only difference is that my rear brake line blew out and I replaced it but I cant get the rear to activate again. Cracked all the bleeders and they are all...
Forum: 2nd Generation S-series (1995-2005) Tech
01-21-2008, 05:54 PM
Replies: 2
Views: 991
Posted By 1blkblazer422

Rear hatch pops when put in nuetral or park

When i put my 96 blazer in nuetral or park after driving it the rear hatch always pops open. Also when I hit the unlock button from my key fob or inside vehicle. Anyone else ever have this problem....
Forum: 2nd Generation S-series (1995-2005) Tech
01-17-2008, 08:03 PM
Replies: 28
Views: 10,759
Posted By 1blkblazer422

RE: '99 LT 4WD Service Light

Have the same problem as you guys with the 4wd switch not lighting up and workin for a milisecond when i turn ignition on. I have already gone threw a few steps. First thing I got was a TCCM from a...
Forum: Steering, Suspension & Drivetrain
12-09-2007, 11:58 AM
Replies: 2
Views: 15,969
Posted By 1blkblazer422

No 4WD with CO308 code

I have no 4wd in my 2001 blazer. The switch will not light up in any of the 4 functions. I have scanned it with a Tech 2 and got a C0308 Motor A/B circuit low code. Any ideas? Thanks
Showing results 1 to 34 of 34


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands