Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: BlazerLove
Showing results 1 to 19 of 19
Search took 0.00 seconds.
Forum: General Chat
02-17-2009, 10:05 PM
Replies: 90
Views: 5,252
Posted By BlazerLove

RE: post your desktops, so we can judge the value of your life

http://img503.imageshack.us/my.php?image=desktoppictureyw0.jpg
Forum: Engine & Transmission
02-06-2009, 06:16 AM
Replies: 10
Views: 13,071
Posted By BlazerLove

RE: '96 4.3 thermostat problem

Let me know when they find whats wrong with yours so i can try and fix mine. I don't exactly have all the good connections.
Forum: Engine & Transmission
02-06-2009, 12:20 AM
Replies: 10
Views: 13,071
Posted By BlazerLove

RE: '96 4.3 thermostat problem

I replaced the sending unit when I replaced the thermostat the 2nd time around. Made sure it was all teflon'd up. I did purge air from the system as per instructions in another post. Gauge still will...
Forum: Engine & Transmission
02-04-2009, 04:19 PM
Replies: 10
Views: 13,071
Posted By BlazerLove

RE: '96 4.3 thermostat problem

I've had this exact same problem. Exactly as you describe it. Spent hours bleeding the cooling system of any air pockets-no success in wasting gas in the drive way... Changed the thermostat twice now...
Forum: Engine & Transmission
02-04-2009, 02:59 AM
Replies: 11
Views: 1,553
Posted By BlazerLove

RE: missfire question

If the misfire is only occuring in the #2 cylinder, even after changing out the plugs it could be a bad wire. I'd go with the above suggestion about the cap and rotor if i were you just to be safe.
Forum: Engine & Transmission
02-03-2009, 11:07 PM
Replies: 11
Views: 1,553
Posted By BlazerLove

RE: missfire question

Try running a few bottles of Techron Chevron through it and see if it helps at all.
Forum: Engine & Transmission
02-03-2009, 11:04 PM
Replies: 5
Views: 1,040
Posted By BlazerLove

RE: Odd Issue

Anybody else have any ideas? I'm worried that it may be the tranny.. and usually problems with the tranny only get worse, and that is the scary part-there is no way in hell i can afford a new one. I...
Forum: Engine & Transmission
02-03-2009, 05:10 PM
Replies: 5
Views: 1,040
Posted By BlazerLove

RE: Odd Issue

The RPM's do drop by about 500 when this 'disengage' occurs.

When I changed my FPR 3 weeks ago I cleaned the EGR and replaced the O2 sensor. Haven't ever replaced the coil..or TPS.. I will look...
Forum: Engine & Transmission
02-03-2009, 03:12 PM
Replies: 5
Views: 1,040
Posted By BlazerLove

Odd Issue

This one has me kinda stumped. My blazer runs like a champ since I replaced the FPR. However, I have noticed a weird issue while driving. It only happens when I am coasting. I'll have my foot...
Forum: 2nd Generation S-series (1995-2005) Tech
01-20-2009, 10:59 PM
Replies: 1
Views: 4,483
Posted By BlazerLove

P1133

O2 Sensor, Insufficient Switching.

I was able to get this code off of my PCM. What does this mean? I replaced my post-cat sensor and the code has since gone away (SES light went out).. however,...
Forum: Article Submissions/Discussions
01-20-2009, 10:56 PM
Replies: 39
Views: 17,820
Posted By BlazerLove

RE: DIY fuel pressure regulator on Blazer 4.3L CPI engine - DISCUSSION

Last weekend I replaced my fuel pressure regulator, I just scoped out and dug in :D. The truck starts right up and idles like a top now, not to mention gas mileage has improved significantly. This...
Forum: Article Submissions/Discussions
12-11-2008, 02:55 AM
Replies: 39
Views: 17,820
Posted By BlazerLove

RE: DIY fuel pressure regulator on Blazer 4.3L CPI engine - DISCUSSION

Definitely do appreciate it swartlkk. Hope the surgery goes well. God bless.
Forum: Article Submissions/Discussions
12-09-2008, 10:11 PM
Replies: 39
Views: 17,820
Posted By BlazerLove

RE: DIY fuel pressure regulator on Blazer 4.3L CPI engine - DISCUSSION

Is there any hope of getting the rest of this article re-written? My FPR has gone bad..and the Haynes manual doesnt do a very good job at covering the replacement procedure. I'd rather not take it to...
Forum: Engine & Transmission
12-02-2008, 01:47 PM
Replies: 32
Views: 24,902
Posted By BlazerLove

RE: Engine will not heat up.

That could be possible. If you didn't seat the seal right coolant could easily just leakright past the thermostat. Like swartlkk said earlier, the thermostat is the master controller of the coolant...
Forum: Engine & Transmission
12-02-2008, 03:02 AM
Replies: 32
Views: 24,902
Posted By BlazerLove

RE: Engine will not heat up.

I had this same problem last year. My thermostat was stuck wide open, after I replaced it the truck heated right up to normal operating temp. Thermostats are cheap and easy fixes. There is a good...
Forum: 2nd Generation S-series (1995-2005) Tech
11-07-2008, 02:13 AM
Replies: 8
Views: 1,972
Posted By BlazerLove

RE: hard starting at times

I am having the exact same problem as described in this thread. Not trying to hi-jack, I just don't want to start a completely new thread. One single question - if she still starts after cranking for...
Forum: Engine & Transmission
06-27-2008, 09:01 AM
Replies: 2
Views: 668
Posted By BlazerLove

RE: Torque converter sticking

I've had this problem before. Try running it on the highway for a few miles and then see if it is still doing it. If it is, and if it gets worse then check your fluid level, also when was the last...
Forum: New Member Area
06-22-2008, 01:03 AM
Replies: 7
Views: 536
Posted By BlazerLove

Greetings from East Tennessee

Hey guys,
I've been using this forum for months now, the wealth of information you guys have provided has allowed me to do a whole 'ton' of stuff to my Blazer. So I figured it would only be my...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands