Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: dg98adams
Showing results 1 to 12 of 12
Search took 0.00 seconds.
Forum: 2nd Generation S-series (1995-2005) Tech
04-16-2012, 02:06 PM
Replies: 6
Views: 1,248
Posted By dg98adams

Dude you video is a good way to loose a couple...

Dude you video is a good way to loose a couple fingers!!!!:icon_omg:

If you blip the throttle/cable cable and rev the engine and the tensioner "dances" after it returns to idle, the tensioner has...
Forum: 2nd Generation S-series (1995-2005) Tech
01-21-2011, 11:56 AM
Replies: 9
Views: 3,083
Posted By dg98adams

The rear prop rods in my 99 4 door Blazer are...

The rear prop rods in my 99 4 door Blazer are also on the way out.
I found the Strong Arm gas rods at my Local Advance, but there is already 1 review where they did not last a week.

I check...
Forum: 2nd Generation S-series (1995-2005) Tech
10-28-2010, 09:49 AM
Replies: 8
Views: 971
Posted By dg98adams

It's the tensioner you need to replace.... if...

It's the tensioner you need to replace.... if it's bouncing around a lot at idle then it's bad. they are like $25.

I usually get 2 tensioners per belt life.

You should never have to add...
Forum: 2nd Generation S-series (1995-2005) Tech
09-16-2010, 09:44 AM
Replies: 22
Views: 22,436
Posted By dg98adams

I believe it connects to the T. Mine broke, and...

I believe it connects to the T. Mine broke, and the lower hose disappeared. I lost the heater vac control like you said.

I found the hose laying under the abs module.

I replaced the T, and...
Forum: 2nd Generation S-series (1995-2005) Tech
09-15-2010, 10:28 AM
Replies: 3
Views: 11,574
Posted By dg98adams

One place that gets missed is the oil drain plug...

One place that gets missed is the oil drain plug is supposed to have a teflon washer replaced at every oil change. I found that out only when I picked up the manual looking for something else. They...
Forum: 2nd Generation S-series (1995-2005) Tech
09-15-2010, 10:25 AM
Replies: 4
Views: 7,196
Posted By dg98adams

You really gotta make sure the slider pins are...

You really gotta make sure the slider pins are not pitted and regreased when you reassemble the rear discs. I've also had to replace the rear hoses, as the sharp bends collect junk or the lines...
Forum: 2nd Generation S-series (1995-2005) Tech
07-01-2010, 08:05 AM
Replies: 6
Views: 12,335
Posted By dg98adams

The gears in the motor can strip out or break......

The gears in the motor can strip out or break... sounds like that's what you have since you can pull the glass up/down. My motor was intermittent..

Pop the door panel and make sure it's in the...
Forum: 2nd Generation S-series (1995-2005) Tech
05-26-2010, 05:21 AM
Replies: 6
Views: 12,335
Posted By dg98adams

The rivets were solid, and by checking the motor...

The rivets were solid, and by checking the motor once it was removed, the motor would hang up on the downward rotation uness i nudged the gear.
Forum: 2nd Generation S-series (1995-2005) Tech
04-12-2010, 12:38 PM
Replies: 6
Views: 12,335
Posted By dg98adams

99 Blazer - bad power window - fix & tips

The drivers power window quit working after hearing a few clicks when I tried to roll it down. I got it 1/2 half way down then it was stuck. The switch works, because I got +12 & -12 volts at the...
Forum: 2nd Generation S-series (1995-2005) Tech
03-01-2010, 06:48 AM
Replies: 4
Views: 1,997
Posted By dg98adams

I wasn't able to get behind the bumper...but that...

I wasn't able to get behind the bumper...but that makes sense. Maybe there is something I can remove to get access? I'll check when the driveway is cleared and it gets a bit warmer.

Thanks
Forum: 2nd Generation S-series (1995-2005) Tech
02-28-2010, 01:06 AM
Replies: 4
Views: 1,997
Posted By dg98adams

bump...any help here?

bump...any help here?
Forum: 2nd Generation S-series (1995-2005) Tech
11-08-2009, 05:42 PM
Replies: 4
Views: 1,997
Posted By dg98adams

99 Blazer - bumper license plate lamps - fit???

Both of the license plate lamps had to have both bulbs recently. Now I can not figure out how to get the white lamp lens back into the bumper??????

I had to by a new lens because I broke the...
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands