Blazer Forum - Chevy Blazer Forums - Search Results
Blazer Forum - Chevy Blazer Forums

Go Back  Blazer Forum - Chevy Blazer Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Used Blazers
Vendor Directory
Search: Posts Made By: broke33
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Forum: Engine & Transmission
05-01-2007, 10:45 PM
Replies: 7
Views: 24,049
Posted By broke33

RE: Replaced tranny, now car wont turn over to start

Fixed it!!

When plugging in one of the forbidden connectors on the PRNDL switch, there was so much gunk in the connector that one of the mating connector pins was bent away from the connector...
Forum: Engine & Transmission
04-30-2007, 07:37 PM
Replies: 7
Views: 24,049
Posted By broke33

RE: Replaced tranny, now car wont turn over to start

Well I bought a ground strap and attached is right to the lower starter bolt and drilled a hole in the frame and attached the other end of the strap. No change. Still did not try to start. I then...
Forum: Engine & Transmission
04-30-2007, 05:08 PM
Replies: 7
Views: 24,049
Posted By broke33

RE: Replaced tranny, now car wont turn over to start

Thanks again for the info. If you find any specific location let me know. I just dont rememeber disconnecting a ground strap. Maybe Ill just go buy 1 from the auto store and attach it to the lower...
Forum: Engine & Transmission
04-30-2007, 07:34 AM
Replies: 4
Views: 977
Posted By broke33

RE: Can someone help a girl out?

Does the heater blow hot air? Could be a clogged heater core. Might want to try having a rdiator flush done at your local oil change place and I would recommend putting the thermostat back in.
Forum: Engine & Transmission
04-30-2007, 07:32 AM
Replies: 7
Views: 24,049
Posted By broke33

RE: Replaced tranny, now car wont turn over to start

That makes perfect sense!. I hadnt even thought about the ground. Any idea where the grounding straps would be located on this vehicle? Does it bolt to one of the top bellhousing bolts or is there...
Forum: Engine & Transmission
04-29-2007, 07:46 AM
Replies: 7
Views: 24,049
Posted By broke33

Replaced tranny, now car wont turn over to start

I have a 1997 Chevy Blazer with the 4L60E transmission. I removed the transmission to replace the front pump seal (it was leaking) and now that Ive placed it back into the truck, the vehicle doesnt...
Forum: 2nd Generation S-series (1995-2005) Tech
03-18-2007, 08:03 PM
Replies: 3
Views: 10,547
Posted By broke33

RE: How do the quick connect transmission cooler lines attach to the 4L60E tranny?

Thanks for the info, but I cant get these lines to snap in. How hard do I need to push? Is it easier to unscrew the adpaters on the side of the trans, snap the lines in, then screw the adapters back...
Forum: 2nd Generation S-series (1995-2005) Tech
03-17-2007, 08:20 PM
Replies: 3
Views: 10,547
Posted By broke33

How do the quick connect transmission cooler lines attach to the 4L60E tranny?

I just purchased a 1996 Chevy Blazer 4x4 and it had a front pumpeal leak. I pulled the trans out, replaced the seal and Im putting it back in. I have the bellhousing bolted up, but I cant figure out...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

© 2021 MH Sub I, LLC dba Internet Brands